Cardone 66-4322 CV Axle Assembly - Front Right

Cardone CV Axle Assembly for Honda Accord

Cardone 66-4322 is a new CV axle assembly engineered for front right service on select Honda Accord applications. Built for 2013-2014 Honda Accord, front right, it is designed to restore smooth driveline operation, reduce vibration, and support consistent power transfer from the transaxle to the wheel.

Key Features

• Fits 2013-2014 Honda Accord, front right
• Cardone CV Axle Assembly, part number 66-4322
• New axle retaining nut included for service convenience
• Splined input shaft with 31 splines
• Splined output shaft with 30 splines
• Neoprene boots with added bellows where needed to help resist stress and ozone cracking
• Boot clamps are pneumatically crimped for a secure boot-to-housing seal
• High-temperature, high-torque grease supports long-term joint performance
• Individually verified shaft straightness helps reduce vibration at speed
• ABS ring not included

Product Details

Cardone applies extensive CV axle testing and engineering experience to this driveline component, using design updates aimed at addressing common failure points found in original equipment axles. The shaft is checked for straightness to help maintain vibration-free operation, while the boot and grease package are selected to support durability under heat, torque, and road exposure. This makes 66-4322 a practical replacement for a worn or noisy front right axle on the Honda Accord.

This part cross-references Honda 44305T2BA00 for the same application.

Common Problems This Axle Can Address

• Clicking or snapping noises during hard turns and acceleration
• Grease leakage around the axle boot or suspension area
• Front-end vibration under load or at speed
• Grinding or popping from a worn outer CV joint
• Axle-related driveline noise after boot failure or joint wear

Installation Notes

• Fits 2013-2014 Honda Accord, front right
• Do not let the axle hang unsupported during service; this can damage the inner joint
• Use a torque wrench for the retaining nut and tighten to the vehicle manufacturer’s specification
• Do not reuse a prevailing-torque axle nut; replace it with the supplied nut
• Replace transaxle seals when servicing CV axle assemblies to help prevent leaks
• If the ABS light is on after installation, inspect the sensor ring, sensor, and nearby wiring for damage

Quality Assurance

Cardone’s CV axle engineering process focuses on runout control, boot durability, and joint performance to support reliable replacement service. Each shaft is inspected for straightness, and the assembly is built to meet OE-level performance expectations for the Honda Accord front right application.