/live/media/A1/A1_664346_Fro.jpg)
Cardone 66-4346 CV Axle Assembly - Rear Right
| Brand | Cardone 66-4346 |
|---|---|
| Position | Rear Right |
| ABS Ring Included | No |
| ABS Ring Tooth Count | 0 |
| Axle Nut Locking Type | Stake |
| Compressed Length (in) | 31.9488 |
| E-Waste | No |
| Input Shaft Connection Style | Splined |
| Input Shaft Spline Count | 20 |
| Output Shaft Connection Style | Splined |
| Output Shaft Spline Count | 23 |
| Package Contents | Complete Axle, Instruction Sheet |
| Product Condition | New |
| Spindle Nut Included | Yes |
| Product line | CV Axle Assembly |
| Fits | Honda · 1 vehicle |
OE performance. Engineered to meet or exceed original equipment standards.
Neoprene boots. Extra bellows help resist stress and ozone cracking.
Precision-verified shafts. Individually checked for straightness to reduce vibration.
Cross-references Honda 42310T0A000 for the same application. See all 1.
Rear Right CV Axle for 2012 Honda CR-V
Cardone 66-4346 is a new CV axle assembly for the rear right position on the 2012 Honda CR-V. It is engineered for direct replacement service with attention to shaft straightness, boot durability, and seal integrity for smoother driveline operation.
Key Features
- Fits 2012 Honda CR-V, rear right
- New CV axle assembly for driveline and axle service
- Splined input shaft connection style with 20 input splines
- Splined output shaft connection style with 23 output splines
- Spindle nut included for installation
- No ABS ring included; ABS ring tooth count is 0
- Neoprene boots use added bellows where needed to reduce stress and ozone cracking
- Boot clamps are pneumatically crimped for a tight seal
- High-temperature, high-torque grease is used for long-term joint protection
- Transmission seal diameter is precision-machined after heat treatment for proper sealing
Product Details
Cardone CV Axle Assembly 66-4346 is built for the rear right driveline position on the 2012 Honda CR-V. CARDONE applies its CV axle engineering and testing experience to address common failure points such as boot cracking, grease loss, contamination, and vibration. Shafts are individually verified for straightness to help maintain vibration-free performance at speed. This part cross-references Honda 42310T0A000 for the same application.
Common Problems This Part Can Address
- Clicking or snapping noises during turns
- Grease on the chassis or suspension from a torn CV boot
- Vibration or thumping during acceleration
- Wobble or binding from a worn outer joint
- Noise caused by contamination entering a damaged axle joint
Installation Notes
- Fits 2012 Honda CR-V, rear right
- Do not let the axle hang unsupported during service
- Use a torque wrench on the retaining nut and tighten to manufacturer specifications
- Do not reuse a prevailing-torque lock nut; install a new nut
- Replace transaxle seals when servicing CV axle assemblies to help prevent leaks
- If the ABS light is on after installation, inspect the sensor ring, sensor, and nearby wiring for damage
Quality Assurance
Cardone designs its CV drive axles around known failure modes in original units and verifies shaft straightness for runout control. The result is a replacement axle built with attention to sealing, balance, and driveline smoothness for the 2012 Honda CR-V rear right application.
| Year | Make | Model | Position | Notes |
|---|---|---|---|---|
| 2012 | Honda | CR-V | Rear Right | CV Axle Assembly |
| No rows match your filter. | ||||