Cardone 66-5241 CV Axle Assembly - Front Left

Cardone CV Axle Assembly for Toyota RAV4

Restore smooth driveline operation with the Cardone 66-5241 CV axle assembly for the front left position on 2001-2003 Toyota RAV4 models. This new axle is built with attention to fit, seal integrity, and vibration control for dependable everyday driving.

Cardone CV axle assemblies are engineered from extensive CV drive axle testing and development, with design choices aimed at reducing common failure points. For the Toyota RAV4 front left application, that means a straight, verified shaft, a sealed boot design, and components selected for consistent performance under load.

Key Features

• Fits 2001-2003 Toyota RAV4, front left
• Part number 66-5241
• New CV axle assembly with complete axle and instruction sheet
• ABS ring included with 48-tooth count
• 23-spline input shaft and 26-spline output shaft
• Stake-style axle nut locking type
• Compressed length: 23.25 in.
• Spindle nut included
• Neoprene boot design with added bellows where needed to reduce boot stress and cracking
• Boot clamps are pneumatically crimped for a tight seal
• High-temperature, high-torque grease for driveline service
• Transmission seal diameter is precision-machined after heat treatment for proper sealing

Detailed Description

The Cardone 66-5241 CV axle assembly is a direct driveline replacement for the front left side of the 2001-2003 Toyota RAV4. It is built to address common CV axle failure causes such as boot cracking, grease loss, contamination, and vibration. Each shaft is individually checked for straightness to help deliver smooth operation at speed, while the included ABS ring supports proper wheel speed signal function on equipped vehicles.

This part cross-references Toyota 4342042050 and 4342042060 for the same application. The Cardone CV Axle Assembly line focuses on OE-style driveline performance with engineering details that support long service life in daily driving conditions.

Common Problems This Part Can Solve

• Clicking or snapping noises during hard turns
• Grease on the chassis or suspension from a ruptured outer boot
• Front-end vibration caused by a bent or out-of-spec axle shaft
• ABS warning light after axle replacement when the sensor ring is damaged or missing
• Grinding or clunking from a worn outer CV joint

Installation Notes and Tips

• Fits 2001-2003 Toyota RAV4, front left
• Do not let the axle hang unsupported during service; this can damage the inner joint
• Use a torque wrench on the retaining nut and tighten to the vehicle manufacturer’s specification
• Do not reuse a prevailing-torque lock nut; install a new nut during service
• Replace transaxle seals when installing a new CV axle assembly to help prevent leaks
• Inspect the ABS sensor, wiring, and ring during installation to avoid speed signal issues

Quality Assurance

Cardone engineers and tests CV drive axles to meet OE-level performance targets, with 100% runout inspection on shafts used in remanufacturing and straightness verification on axle shafts for vibration control. The design also addresses common boot failure causes with reinforced neoprene boot construction and secure crimped clamps.