Cardone 66-5377 CV Axle Assembly - Rear Left

Cardone CV Axle Assembly for Toyota Sequoia

Restore smooth driveline operation with the Cardone CV Axle Assembly, Part Number 66-5377. This new rear left axle is built for 2008-2019 Toyota Sequoia applications and is engineered to address common CV axle failure points with verified shaft straightness, durable boot construction, and precision-machined sealing surfaces.

Key Features

• Fits 2008-2019 Toyota Sequoia, rear left
• Cardone CV Axle Assembly, Part Number 66-5377
• New axle retaining nut supplied for easier service
• 36-spline input and 36-spline output shaft connection
• Neoprene boots with added bellows where needed to resist stress and ozone cracking
• Boot clamps are pneumatically crimped for a secure seal
• High-temperature, high-torque grease for demanding driveline conditions
• Shafts are individually verified for straightness to reduce vibration
• Transmission seal diameter is precision-machined after heat treatment for proper sealing
• Spindle nut included

Product Details

Cardone’s CV Axle Assembly line is engineered around the failure modes commonly seen in original driveline components. For Toyota Sequoia rear left service, Part Number 66-5377 uses a splined 36-to-36 shaft configuration and a compressed length of 34.8425 inches. The design focuses on stable operation, reliable sealing, and consistent performance under load. This part cross-references Toyota 423400C010 for the same application.

Common Problems This Part Can Address

• Clicking or snapping noises during hard turns and acceleration
• Grease leakage from a ruptured outer CV boot
• Vibration caused by a bent or out-of-runout axle shaft
• Grinding or noise from a worn CV joint
• ABS warning issues caused by damaged sensor components during axle service

Installation Notes and Tips

• Fits 2008-2019 Toyota Sequoia, rear left.
• Do not let the CV axle hang unsupported during service; this can damage the inner joint.
• Use a torque wrench on the retaining nut and tighten to the vehicle manufacturer’s specification.
• Do not reuse a prevailing-torque lock nut; install the new nut supplied with the axle.
• Replace transaxle seals when servicing CV drive axle assemblies to help prevent leaks.
• If the ABS light remains on after installation, inspect the sensor ring, sensor, and nearby wiring for damage.

Quality Assurance

Cardone builds this CV axle assembly using engineering methods developed from testing original axle failure patterns. Shafts are checked for straightness, and the boot and seal design is intended to support long-term driveline reliability in Toyota Sequoia rear left applications. New condition, Part Number 66-5377.