Cardone 66-6113 CV Axle Assembly - Front Right

Cardone CV Axle Assembly for Nissan Front Right

Restore smooth driveline operation with the Cardone CV Axle Assembly 66-6113. This new front right axle is built for specific Nissan applications and is engineered to deliver stable, vibration-free performance with the correct ABS ring and spline configuration.

Fits 2000-2001 Nissan Sentra, front right with locking differential. Fits 1995-1997 Nissan 200SX, front right. Fits 1991-1994 Nissan Sentra, front right. Fits 1991-1993 Nissan NX, front right.

Key Features

• Cardone CV Axle Assembly, part number 66-6113
• New unit with complete axle and instruction sheet
• ABS ring included with 42-tooth count
• Supplied spindle nut and axle nut locking type: standard
• Compressed length: 36.375 in.
• 25-spline input and output shaft connection style
• Neoprene boot design with added bellows where needed to reduce stress and cracking
• High-temperature, high-torque grease for consistent joint lubrication
• Individually verified shaft straightness for reduced vibration
• Boot clamps are pneumatically crimped for a secure seal

Product Details

Cardone builds this CV axle assembly using engineering methods developed from testing original drive axle failure points. The boot design addresses common causes of CV axle wear, including ozone cracking and bellows stress, while the shaft is checked for straightness to help maintain smooth operation at speed. For Nissan Sentra, Nissan 200SX, and Nissan NX front right applications, this part number 66-6113 is a direct driveline service replacement that supports proper axle engagement and ABS function.

This part cross-references Nissan 391000M811 and 391004M811 for the same application.

Common Problems This Part Can Address

• Clicking or snapping noises during hard turns and acceleration
• Grease leakage around the axle boot or underbody contamination
• Front-end vibration caused by axle runout or shaft imbalance
• ABS warning light concerns after axle replacement when the sensor ring is damaged or incorrect
• Grinding or wobble from a worn outer CV joint

Installation Notes

• Do not let the CV axle hang unsupported during service; support the shaft to avoid inner joint damage.
• Use a torque wrench on the retaining nut and tighten to the vehicle manufacturer’s specification.
• Do not reuse a prevailing-torque lock nut; install the supplied new nut.
• Replace transaxle seals when servicing CV drive axle assemblies to help prevent leaks.
• Inspect the ABS sensor, wiring, and ring during installation to avoid speed signal issues.

Quality Assurance

Cardone’s CV Drive Axle engineering process focuses on reducing repeat failure by addressing common wear points found in original equipment axles. Each shaft is verified for straightness, and the assembly uses materials and sealing methods selected for dependable driveline performance in Nissan front right applications.