Cardone 66-6132 CV Axle Assembly - Front Left

Cardone CV Axle Assembly for Nissan Altima

Restore driveline performance with the Cardone CV Axle Assembly, part number 66-6132, for select 2002-2006 Nissan Altima front left applications. This new CV axle is engineered for smooth power transfer, stable operation, and dependable fitment on the Nissan Altima front axle.

Key Features

• Fits 2002-2006 Nissan Altima, front left
• ABS ring included with 44-tooth count
• New axle retaining nut supplied for installation
• Compressed length: 24.563 in.
• Splined input shaft: 29 teeth
• Splined output shaft: 27 teeth
• Neoprene boots with added bellows where needed to resist cracking and stress
• Boot clamps are pneumatically crimped for a secure seal
• High-temperature, high-torque grease used for long-lasting joint lubrication
• Shafts are verified for straightness to support vibration-free operation

Product Details

Cardone CV axle assemblies are built from testing and engineering experience focused on reducing common failure points found in original drive axles. For this 66-6132 application, the axle includes an ABS ring and a new spindle nut, and the shaft is checked for straightness to help maintain smooth operation at speed. The design also addresses boot durability with neoprene construction and improved bellows geometry where required, helping resist ozone cracking and bellow stress. This part cross-references Nissan OE numbers 391018J000 and 391018J010 for the same application.

Common Problems This Part Can Address

• Clicking or snapping noises during hard turns and acceleration
• Grease leakage around the axle boot or suspension area
• Front-end vibration caused by axle runout or shaft imbalance
• ABS warning light concerns related to axle sensor ring damage or signal issues
• Grinding or thumping from a worn outer or inner CV joint

Installation Notes

• Fits 2002-2006 Nissan Altima, front left.
• Do not let the axle hang unsupported during service; support the assembly to avoid joint damage.
• Use a torque wrench on the retaining nut and tighten to the vehicle manufacturer’s specification.
• Do not reuse a prevailing-torque lock nut; replace it with the supplied nut.
• Replace transaxle seals when servicing CV axle assemblies to help prevent leaks.
• If the ABS light remains on after installation, inspect the sensor ring, sensor, and nearby wiring for damage.

Quality Assurance

Cardone designs CV drive axles to meet or exceed original equipment performance targets through application-specific engineering, straightness verification, and improved boot and seal details. The 66-6132 is a new CV axle assembly built for consistent driveline operation on the Nissan Altima.