Cardone 66-6179 CV Axle Assembly - Front Left

Cardone CV Axle Assembly for Nissan Altima

Restore front-end driveline performance with the Cardone CV Axle Assembly, part number 66-6179. This new axle is built for 1998-2001 Nissan Altima front left applications and is engineered for smooth power transfer, stable operation, and reduced vibration.

Key Features

• Fits 1998-2001 Nissan Altima, front left
• Cardone CV Axle Assembly, part number 66-6179
• ABS ring included with 44 teeth
• New spindle nut included
• Splined input shaft with 29 splines and splined output shaft with 27 splines
• Compressed length: 24.9375 in.
• Neoprene boots with added bellows where needed to resist stress and ozone cracking
• Boot clamps are pneumatically crimped for a secure seal
• High-temperature, high-torque grease for consistent joint lubrication
• Shafts are individually verified for straightness to help reduce vibration

Product Details

Cardone designs its CV Drive Axle line around common failure points found in original equipment units. For the Nissan Altima front left axle, that means attention to boot durability, shaft straightness, seal surface quality, and joint protection. The result is a replacement axle assembly intended to deliver OE-style driveline function on daily-driven vehicles. Part number 66-6179 is a direct-fit option for 1998-2001 Nissan Altima models listed in the fitment data.

This part cross-references Nissan OE numbers 391010Z805 and 391019E105 for the same application.

Common Problems This Part Addresses

• Clicking or snapping noises during turns
• Grease leakage around the axle boot or suspension
• Front-end vibration during acceleration
• ABS warning light after axle replacement when the sensor ring is damaged or mismatched
• Grinding or binding from a worn outer or inner CV joint

Installation Notes

• Fits 1998-2001 Nissan Altima, front left
• Do not let the axle hang unsupported during service; this can damage the inner joint
• Use a torque wrench on the retaining nut and tighten to the vehicle manufacturer’s specification
• Do not reuse a prevailing-torque lock nut; install the supplied new spindle nut
• Replace transaxle seals when servicing CV axle assemblies to help prevent leaks
• Inspect the ABS sensor, wiring, and ring during installation to avoid an ABS fault

Quality Assurance

Cardone applies testing and engineering methods developed from CV axle remanufacturing experience to improve fit, balance, and durability. Shafts are checked for straightness, and the axle design addresses boot failure and seal life concerns that commonly affect driveline service parts. Part number 66-6179 is a new component with OE-focused construction details for the Nissan Altima platform.