Cardone 66-6209 CV Axle Assembly - Front Left

Cardone CV Axle Assembly for Nissan Altima and Maxima

Cardone CV Axle Assembly 66-6209 is a new front left driveline replacement engineered for specific Nissan applications. It is built with a splined 29-tooth input and output connection, an ABS ring with 44 teeth, and a standard axle nut locking type for direct-service replacement on the listed vehicles.

Key Features

• Fits 2002-2003 Nissan Altima, front left
• Fits 2004 Nissan Altima, front left, before 01/2004
• Fits 2004 Nissan Maxima, front left
• ABS ring included with 44 teeth for speed sensor signal support
• Compressed length: 25.5 in.
• Splined 29-tooth input shaft and 29-tooth output shaft
• New spindle nut included
• Complete axle and instruction sheet in the package
• Cardone part number 66-6209

Product Details

Cardone’s CV Axle Assembly line is engineered around common failure points found in original CV drive axles. This assembly uses a neoprene boot design with added bellows where needed to reduce boot stress and ozone cracking, helping address one of the most common causes of CV joint failure. The shaft is individually verified for straightness to support vibration-free operation at speed, and the axle is built with high-temperature, high-torque grease for consistent joint lubrication. For Nissan Altima and Nissan Maxima front left service, 66-6209 provides a direct replacement format for driveline repair work.

This part cross-references Nissan (e.g., 391017Y015, 391018J105) for the same application.

Common Problems This Part Can Address

• Clicking or snapping noise during hard turns and acceleration
• Grease leakage around the axle boot or suspension area
• Front-end vibration caused by a bent or out-of-runout axle shaft
• ABS warning light triggered by a damaged sensor ring or related axle component
• Grinding or clunking from a worn outer or inner CV joint

Installation Notes and Tips

• Fits 2002-2003 Nissan Altima, front left; 2004 Nissan Altima, front left before 01/2004; and 2004 Nissan Maxima, front left.
• Do not let the CV axle hang unsupported during service.
• Use a torque wrench on the retaining nut and tighten to manufacturer specifications.
• Do not reuse a prevailing-torque lock nut; install the supplied new spindle nut.
• Replace transaxle seals when servicing the axle to help prevent leaks.
• If the ABS light remains on after installation, inspect the sensor ring, sensor, and nearby wiring for damage.

Quality Assurance

Cardone designs and tests CV drive axles to meet or exceed original equipment performance targets. Shafts are checked for straightness to help reduce vibration, and the axle construction is focused on durability at high torque and temperature. Part number 66-6209 is a new assembly for direct replacement service.