Cardone 66-6241 CV Axle Assembly - Front Right

Cardone CV Axle Assembly for Nissan Quest

Cardone 66-6241 is a new CV axle assembly built for the front right position on select 2004-2009 Nissan Quest models. It is engineered for smooth driveline operation, with a verified straight shaft, sealed joints, and an included ABS ring for proper sensor signal support.

Key Features

• Fits 2004-2009 Nissan Quest, front right
• Cardone CV Axle Assembly, part number 66-6241
• ABS ring included for vehicles equipped with ABS
• New axle retaining nut and spindle nut included
• Compressed length: 41.3125 in.
• 26-spline input shaft and 29-spline output shaft
• Neoprene boots with added bellows to resist cracking and stress
• Boot clamps are pneumatically crimped for a secure seal
• Precision-machined transmission seal diameter after heat treatment
• High-temperature, high-torque grease for driveline service

Product Details

Cardone applies its CV axle engineering and testing experience to this 66-6241 assembly to address common failure points found in original driveline components. The shaft is individually checked for straightness to help reduce vibration, while the boot design and sealing details are focused on keeping grease in and contamination out. For Nissan Quest front right axle replacement work, this part provides a direct-fit driveline solution with the ABS ring already in place.

This part cross-references Nissan 39100CK005 for the same application.

Common Problems This Part Can Address

• Clicking or snapping noise during turns
• Grease leakage around the CV boot or suspension area
• Front-end vibration during acceleration
• Grinding noise from a worn outer CV joint
• ABS warning light caused by axle sensor ring damage or signal issues

Installation Notes and Tips

• Fits 2004-2009 Nissan Quest, front right.
• Do not let the axle hang unsupported during service; this can damage the inner joint.
• Use a torque wrench on the retaining nut and tighten to the vehicle manufacturer’s specification.
• Do not reuse a prevailing-torque lock nut; install the supplied new nut.
• Replace transaxle seals when servicing CV axle assemblies to help prevent leaks.
• Inspect the ABS sensor, wiring, and ring during installation to avoid warning light concerns.

Quality Assurance

Cardone designs this CV axle assembly around known OE failure points and verifies shaft straightness for vibration control. The assembly is new and includes an ABS ring, with sealing and boot construction intended to support long-term driveline service on the Nissan Quest.