Cardone 66-6262 CV Axle Assembly - Front Left

Cardone CV Axle Assembly for Nissan Front Left

Cardone 66-6262 is a new front left CV axle assembly engineered for smooth driveline operation and OE-style fitment. It is built for select Nissan Rogue, Rogue Select, Altima, and Sentra applications, with attention to boot durability, shaft straightness, and consistent joint performance.

Key Features

• Fits 2014-2015 Nissan Rogue Select, front left
• Fits 2007-2013 Nissan Altima, front left
• Fits 2008-2013 Nissan Rogue, front left
• Fits 2007-2012 Nissan Sentra, front left
• ABS ring included for applications that require wheel speed signal support
• New axle retaining nut supplied for installation
• Neoprene boots with added bellows where needed to reduce stress and ozone cracking
• Boot clamps are pneumatically crimped for a secure seal
• High-temperature, high-torque grease supports long service life
• Shafts are individually verified for straightness to reduce vibration
• Input shaft: 27 splines; output shaft: 29 splines
• Compressed length: 26.1875 in.

Product Details

This Cardone CV Axle Assembly is part of the Cardone CV Axle Assembly line, developed from extensive CV driveline testing and engineering. The design focuses on common failure points found in original axles, including boot cracking, seal wear, and vibration caused by shaft runout. Cardone 66-6262 is a direct-fit front left axle for Nissan Rogue, Nissan Altima, and Nissan Sentra applications listed above, making it a practical replacement for worn or damaged driveline components.

This part cross-references Nissan OE numbers 39101ET80C and 39101JA010 for the same application.

Common Problems This Part Can Address

• Clicking or snapping noises during turns
• Grease leakage around the axle boot or suspension area
• Front-end vibration during acceleration
• ABS warning light caused by a damaged sensor ring or related axle component
• Grinding or binding from a worn outer or inner CV joint

Installation Notes

• Do not let the CV axle hang unsupported during service.
• Use a torque wrench on the retaining nut and tighten to the vehicle manufacturer’s specification.
• Do not reuse a prevailing-torque lock nut; replace it with the supplied new nut.
• Install new transaxle seals when replacing CV axle assemblies to help prevent leaks.
• If the ABS light remains on after installation, inspect the sensor ring, sensor, and nearby wiring for damage.

Quality Assurance

Cardone engineers these CV drive axles to address known OE failure points and verifies each shaft for straightness to support vibration-free operation at speed. The product is new and built for consistent driveline performance in the listed Nissan applications.