Cardone 66-6263 CV Axle Assembly - Front Right

Cardone CV Axle Assembly for Sentra

Restore smooth power delivery with this Cardone CV axle assembly, part number 66-6263. It is built for the front right position on 2007-2012 Nissan Sentra models and is engineered to address common causes of CV axle noise, vibration, and boot failure.

Cardone’s CV axle line focuses on OE-style performance with attention to shaft straightness, boot durability, and seal integrity. For Nissan Sentra front right axle replacement, 66-6263 is designed to deliver consistent driveline operation and dependable fitment.

Key Features

• Fits 2007-2012 Nissan Sentra, front right
• Cardone CV Axle Assembly, part number 66-6263
• ABS ring included for proper wheel speed signal operation
• New spindle nut included
• Castle-style axle nut locking type
• Splined input shaft with 27 splines
• Splined output shaft with 29 splines
• Neoprene boot design with added bellows where needed to help resist stress and ozone cracking
• Boot clamps are pneumatically crimped for a secure seal
• High-temperature, high-torque grease is used for long-term joint protection
• Shafts are individually verified for straightness to help reduce vibration

Product Details

This Cardone CV axle assembly is a new driveline replacement for the front right side of the Nissan Sentra. The design addresses common CV joint failure points by using durable boot construction, precision-machined sealing surfaces, and shaft verification for runout control. If you are replacing a worn or noisy axle on a 2007-2012 Nissan Sentra, part number 66-6263 provides a direct-fit solution for restoring driveline smoothness.

This part cross-references Nissan 39100ET80C for the same application.

Common Problems It Can Help Solve

• Clicking or snapping during turns
• Grease on the chassis or suspension from a torn CV boot
• Front-end vibration during acceleration
• Grinding or popping noises from the driveline
• ABS warning light caused by axle sensor ring or wiring damage during replacement

Installation Notes

Do not let the CV axle hang unsupported during service, as this can damage the inner joint. Always install a new axle nut and torque it to the manufacturer specification with a torque wrench; do not use an impact wrench for final tightening. When replacing CV drive axle assemblies, install new transaxle seals to help prevent leaks. If the original axle nut is a prevailing-torque style, do not reuse it.

Quality Assurance

Cardone engineers and tests its CV drive axles to meet OE-level performance targets. The shafts are checked for straightness to help prevent vibration, and the boot and grease design are selected to improve durability under heat, torque, and road exposure.