Cardone 66-6290 CV Axle Assembly - Front Right

Cardone CV Axle Assembly for Versa

Cardone 66-6290 is a new CV axle assembly engineered for OE-style driveline performance on the front right side of the Nissan Versa. It is built with a splined 25-tooth input and output connection, an ABS ring, and a supplied spindle nut for a cleaner replacement on 2009-2011 Nissan Versa applications.

Key Features

• Fits 2009-2011 Nissan Versa, front right
• New CV axle assembly with complete axle and instruction sheet
• ABS ring included for vehicles equipped with wheel speed sensing at the axle
• Supplied spindle nut and standard axle nut locking type
• 25-spline input shaft and 25-spline output shaft
• Compressed length: 35.5 in.
• Neoprene boots with added bellows where needed to reduce stress and ozone cracking
• Boot clamps are pneumatically crimped for a tight seal
• Heat-treated, precision-machined seal diameter for long seal life
• High-temperature grease formulated for torque and heat load

Built for OE-Style Performance

Cardone focuses on the failure points that commonly affect CV drive axles, including boot cracking, seal wear, and shaft runout. Each shaft is individually verified for straightness to help deliver vibration-free operation, while the remanufacturing and engineering process is designed to meet or exceed original equipment performance. This part cross-references Nissan 39100EL10A for the same application. Cardone 66-6290 is a direct replacement choice for Nissan Versa front right axle service when the original axle shows wear, noise, or grease loss.

Common Problems This Part Can Address

• Clicking or snapping during hard turns
• Grease on the chassis or suspension from a torn outer boot
• Front-end vibration during acceleration
• Grinding or popping noises from the driveline
• ABS warning light after axle replacement when the sensor ring is damaged or missing

Installation Notes and Tips

• Fits 2009-2011 Nissan Versa, front right only.
• Do not let the axle hang unsupported during service; this can damage the inner joint.
• Use a torque wrench on the retaining nut and tighten to manufacturer specifications.
• Do not reuse a prevailing-torque lock nut; install the supplied new nut.
• Replace transaxle seals when servicing CV axle assemblies to help prevent leaks.
• Inspect the ABS sensor, wiring, and ring during installation to avoid speed signal faults.

Quality Assurance

Cardone applies testing and engineering methods developed from extensive CV axle experience, including 100% shaft runout inspection to help prevent vibration. The design also addresses common boot and seal failure points to support reliable service life on Nissan Versa driveline repairs.