Cardone 66-6307 CV Axle Assembly - Front Right

Cardone CV Axle Assembly for Altima

Restore smooth power transfer with this Cardone CV axle assembly, engineered for front right service on select Nissan Altima models. Part number 66-6307 is built with attention to axle straightness, boot durability, and seal integrity for dependable driveline performance.

Key Features

• Fits 2007-2011 Nissan Altima, front right
• Cardone CV Axle Assembly, part number 66-6307
• ABS ring included for proper wheel speed signal operation
• New axle retaining nut and spindle nut included
• Splined input and output shaft connections
• 24-spline input shaft and 29-spline output shaft
• Compressed length: 25.4375 in.
• Neoprene boots with added bellows where needed to reduce stress and ozone cracking
• High-temperature, high-torque grease for driveline durability
• Individually verified shaft straightness for reduced vibration

Product Details

Cardone CV axle assemblies are engineered from testing and remanufacturing experience focused on common CV failure points. For this Nissan Altima front right application, the axle uses a precision-machined transmission seal diameter after heat treatment to help promote proper sealing and long service life. Boot clamps are pneumatically crimped to create a secure seal between the boot and housing, while the shaft is checked for runout to help maintain smooth operation at speed. Part number 66-6307 is a direct driveline replacement for the specified Altima fitment and is also referenced under Nissan 39101JA020.

This part cross-references Nissan 39101JA020 for the same application.

Common Problems This Axle Can Address

• Clicking or snapping noises during hard turns
• Grease leakage around the CV boot or suspension area
• Front-end vibration during acceleration
• Wobble or binding while turning
• ABS warning light concerns after axle replacement when the sensor ring is damaged or missing

Installation Notes

• Fits 2007-2011 Nissan Altima, front right.
• Do not let the axle hang unsupported during service; this can damage the inner joint.
• Use a torque wrench on the retaining nut and tighten to manufacturer specifications.
• Do not reuse a prevailing-torque lock nut; replace it with the supplied nut.
• Replace transaxle seals when servicing CV drive axle assemblies to help prevent leaks.
• Inspect the ABS sensor, wiring, and ring during installation to avoid speed signal issues.

Quality Assurance

Cardone designs CV drive axles to address common failure causes found in original units, including boot cracking, seal wear, and vibration from shaft runout. Each shaft is individually verified for straightness to support vibration-free performance across the operating range.