Cardone 66-7010 CV Axle Assembly - Front Right

CV Axle Assembly for Volkswagen Golf and Jetta

Cardone 66-7010 is a new CV axle assembly for the front right position on select Volkswagen Golf and Volkswagen Jetta models. It is built for 1985-1992 Volkswagen Golf and 1985-1992 Volkswagen Jetta applications with a 100 mm diameter inboard joint.

Key Features

• Fits front right applications on select Volkswagen Golf and Jetta models
• New axle retaining nut included for service replacement
• ABS ring included
• Self-lock axle nut locking type
• 22-spline output shaft with bolt-on input shaft connection
• High-temperature grease formulated for driveline loads
• Neoprene boots with added bellows where needed to reduce stress and cracking
• Boot clamps are pneumatically crimped for a secure seal
• Shafts are individually verified for straightness to reduce vibration

Product Details

Cardone CV Axle Assembly 66-7010 is engineered for OE-style driveline service on Volkswagen Golf and Volkswagen Jetta front right applications. CARDONE’s CV axle program focuses on common failure points such as boot cracking, grease loss, contamination, and shaft runout. This assembly uses precision-machined sealing surfaces after heat treatment, high-quality grease, and verified shaft straightness to support smooth operation at speed. This part cross-references Volkswagen (e.g., 191407272AF, 191407272BD) for the same application.

Common Problems This Part Addresses

• Clicking or snapping during hard turns
• Grease on the chassis or suspension from a torn outer boot
• Vibration during acceleration from axle runout or imbalance
• Grinding or noise from a worn CV joint
• ABS warning light after axle replacement when the sensor ring is damaged

Installation Notes and Tips

• Fits 1985-1992 Volkswagen Golf, front right, with 100 mm diameter inboard joint.
• Fits 1985-1992 Volkswagen Jetta, front right, with 100 mm diameter inboard joint.
• Do not let the axle hang unsupported during service; this can damage the inner joint.
• Use a torque wrench on the retaining nut and tighten to the manufacturer specification.
• Do not reuse a prevailing-torque lock nut; install the supplied new nut.
• Replace transaxle seals when servicing the axle to help prevent leaks.

Quality Assurance

Cardone engineers and tests its CV drive axles to address repeat-failure causes found in original units. Each shaft is checked for straightness, and the assembly uses boot and seal details selected to support long service life and vibration-free performance.