Cardone 66-7243 CV Axle Assembly - Front Right

Cardone CV Axle Assembly for Audi A4 Quattro

Cardone 66-7243 is a new CV axle assembly engineered for front right service on 1996-2001 Audi A4 Quattro applications. Built for driveline repair, it addresses common axle-related noise, vibration, and boot failure concerns with a design focused on OE-level fit and function.

Key Features

• Fits 1996-2001 Audi A4 Quattro, front right
• ABS ring included with 45 teeth for proper speed signal operation
• New axle retaining nut supplied for service convenience
• Neoprene boot design with added bellows where needed to reduce stress cracking
• High-temperature grease formulated for torque and heat demands
• Shafts individually verified for straightness to help reduce vibration
• Input shaft bolt-on design with 6 bolt count
• Output shaft splined connection with 38 spline count

Product Details

This Cardone CV axle assembly is built around the company’s remanufacturing and engineering experience in CV drive axles, with attention to the failure points that commonly affect original units. The axle shaft is checked for runout and straightness, while the boot and grease package are selected to support long-term joint protection. For Audi A4 Quattro front right repair work, Cardone 66-7243 provides the correct driveline configuration, including the ABS ring and spindle nut details needed for a proper replacement.

This part cross-references Audi 8D0407272AH and 8D0407452EX for the same application.

Common Repair Symptoms

• Clicking or snapping during hard turns and acceleration
• Grinding noise from the front end with grease on the chassis or suspension
• Vibration or thump under load when accelerating
• ABS warning light after axle replacement or sensor-ring damage
• Wobble or binding during turns caused by a worn CV joint

Installation Notes

• Fits 1996-2001 Audi A4 Quattro, front right
• Do not let the axle hang unsupported during service; this can damage the inner joint
• Use a torque wrench on the retaining nut and follow manufacturer torque specifications
• Do not reuse a prevailing-torque lock nut; install a new nut during assembly
• Replace transaxle seals when servicing CV drive axle assemblies to help prevent leaks
• Inspect the ABS ring, sensor, and nearby wiring during installation to avoid speed signal faults

Quality Assurance

Cardone designs CV drive axles to address common OE failure causes, including boot cracking, joint contamination, and shaft runout. The axle shaft is individually verified for straightness, and the boot and grease selection are intended to support consistent driveline performance in Audi A4 Quattro applications.