Cardone 66-7328 CV Axle Assembly - Front Left

Cardone CV Axle Assembly for Audi A4 Quattro

Restore smooth driveline operation with the Cardone CV Axle Assembly, part number 66-7328. This new front left axle is built for 1997-2000 Audi A4 Quattro applications and is engineered to address common CV axle failure points with attention to boot durability, seal life, and shaft straightness.

Key Features

• Fits 1997-2000 Audi A4 Quattro, front left
• Cardone part number 66-7328
• ABS ring included with 45 teeth for proper signal transfer
• New spindle nut included with M14 x 1.5 thread size and 24mm hex head
• Neoprene boot design with added bellows where needed to reduce stress and cracking
• High-temperature, high-torque grease for consistent joint lubrication
• Individually verified shaft straightness for vibration-free operation
• Precision-machined transmission seal diameter after heat treatment for improved seal life

Detailed Description

Cardone CV Drive Axles are engineered from testing and failure analysis to improve on common OE axle weak points. For Audi A4 Quattro front left service, this assembly combines a splined 33-tooth output shaft, bolt-on 6-bolt input connection, and an ABS ring to support correct driveline and wheel-speed sensor operation. The 66-7328 is built as a new replacement axle for 1997, 1998, 1999, and 2000 Audi A4 Quattro models, making it a direct choice for front left CV axle replacement work.

Cardone’s CV axle line focuses on reducing repeat failures by using boot designs that resist ozone cracking and bellows stress, along with carefully controlled shaft verification to limit vibration at speed. This part cross-references Audi 8D0407271AP and 8D0407271BA for the same application.

What It Helps Fix

• Clicking or snapping during turns from a worn outer CV joint
• Grease leakage around the axle boot or chassis area
• Front-end vibration caused by a bent or out-of-straight axle shaft
• ABS warning light issues related to damaged sensor ring or wiring near the axle
• Thumping or driveline shudder during acceleration from CV joint wear

Installation Notes and Tips

• Do not let the axle hang unsupported during service; support the driveline to avoid joint damage.
• Use a torque wrench on the retaining nut and tighten to the vehicle manufacturer’s specification.
• Replace the prevailing torque lock nut instead of reusing the old nut.
• Install new transaxle seals when replacing CV drive axle assemblies to help prevent leaks.
• Inspect the ABS sensor ring, sensor, and nearby wiring before final assembly.

Quality Assurance

Cardone applies engineering and inspection processes focused on driveline durability, including 100% shaft runout verification to help prevent vibration. The axle is supplied new and packaged with an instruction sheet for service reference. Fits 1997-2000 Audi A4 Quattro, front left.