Cardone 66-7352 CV Axle Assembly - Front Left

Cardone CV Axle Assembly for Audi Front Left

Restore smooth driveline operation with this Cardone CV axle assembly, part number 66-7352. It is built for front-left applications on select Audi A4, S4, and RS4 models and is engineered to address common causes of CV joint and boot failure.

Key Features

• Fits 2002-2008 Audi A4, front left
• Fits 2007-2009 Audi S4, front left
• Fits 2007-2008 Audi RS4, front left
• ABS ring included with 45 teeth for proper speed signal operation
• New axle retaining nut supplied for installation
• Spindle nut thread size: M16 x 1.5
• Compressed length: 23.50 in.
• Output shaft spline count: 38
• Input shaft connection style: bolt-on
• Output shaft connection style: splined
• Neoprene boot design with added bellows where needed to reduce stress and cracking
• Boot clamps are pneumatically crimped for a secure seal
• High-temperature, high-torque grease is used for long-term joint protection
• Shafts are individually verified for straightness to help reduce vibration

Product Details

Cardone CV axle assemblies are engineered from testing and remanufacturing experience to address the failure points commonly seen in original CV drive axles. The boot design, seal surfaces, grease selection, and shaft verification process are all focused on stable operation, reduced vibration, and consistent performance. This Cardone 66-7352 axle is a direct-fit driveline replacement for front-left Audi applications and is a practical choice when the original axle shows wear, noise, or boot damage.

This part cross-references Audi 8E0407271AT for the same application.

Common Problems This Part Can Address

• Clicking or snapping noises during turns
• Grease leakage around the axle boot or suspension area
• Vibration during acceleration or at speed
• ABS warning light caused by a damaged sensor ring or related axle issue
• Grinding or clunking from a worn outer or inner CV joint

Installation Notes and Tips

• Do not let the axle hang unsupported during service; this can damage the inner joint.
• Use a torque wrench on the retaining nut and tighten to the vehicle manufacturer’s specification.
• Do not reuse a prevailing-torque lock nut; replace it with the supplied new nut.
• Replace transaxle seals when servicing CV drive axle assemblies to help prevent leaks.
• If the ABS light remains on after installation, inspect the sensor ring, sensor, and nearby wiring for damage.

Quality Assurance

Cardone designs CV drive axles to meet or exceed original equipment performance targets through engineering focused on known failure points. Each shaft is checked for straightness to support vibration-free operation, and the axle is assembled with components selected for durability in high-load driveline service. Part number 66-7352 is a new CV axle assembly for Audi front-left applications.