Cardone 66-8048 CV Axle Assembly - Front Right

Cardone CV Axle Assembly for Mazda MPV

Restore driveline performance with this Cardone CV axle assembly, part number 66-8048, for the front right position on 1989-1998 Mazda MPV models. Built for direct replacement service, it is engineered to address common CV axle failure points while supporting smooth, vibration-free operation.

Key Features

• Fits 1989-1998 Mazda MPV, front right
• Cardone CV Axle Assembly, part number 66-8048
• ABS ring included with 44 teeth
• New spindle nut included; 36mm hex, M24 x 1.5 thread
• Splined 26-tooth input and output shaft connections
• Neoprene boot design with added bellows where needed to reduce stress and ozone cracking
• High-temperature, high-torque grease for demanding driveline conditions
• Shafts individually verified for straightness to help reduce vibration

Product Details

Cardone 66-8048 is a new CV axle assembly for the Mazda MPV front right application. The design focuses on the failure points commonly seen in original CV axles, including boot cracking, grease loss, contamination, and vibration from shaft runout. Precision verification of shaft straightness and careful boot sealing help support consistent driveline performance in everyday driving and under load.

This part cross-references Mazda M08025500, M08025500A, and MD0725500 for the same application.

Common Problems This Part Can Address

• Clicking or snapping noises during hard turns and acceleration
• Grease on the chassis or suspension from a ruptured outer boot
• Front-end vibration or thumping caused by a worn or bent axle shaft
• ABS warning light issues after axle replacement when the sensor ring is damaged or incorrect
• Grinding or binding from a worn inner or outer CV joint

Installation Notes and Tips

• Fits 1989-1998 Mazda MPV, front right.
• Do not let the axle hang unsupported during service; this can damage the inner joint.
• Use a torque wrench for the spindle nut and tighten to the vehicle manufacturer’s specification.
• Do not reuse the prevailing-torque axle nut; install the new nut supplied with the axle.
• Replace transaxle seals when servicing CV drive axles to help prevent leaks.
• If the ABS light remains on after installation, inspect the sensor ring, sensor, and wiring for damage.

Quality Assurance

Cardone engineers and tests CV drive axles to meet or exceed original equipment performance targets. The axle shaft is checked for straightness, and the boot and grease system are designed to help reduce repeat failure from cracking, contamination, and heat-related wear.