Cardone 66-8084 CV Axle Assembly - Front Left

Cardone CV Axle Assembly for Front Left Applications

Cardone CV Axle Assembly 66-8084 is a new front left driveline replacement engineered for specific Mazda and Kia applications. It is built to address common CV axle failure points with verified shaft straightness, improved boot design, and a precision-machined seal surface for dependable operation.

Key Features

• Fits 1995-1998 Mazda Protege, front left
• Fits 1994-1997 Kia Sephia, front left
• Fits 1992-1995 Mazda MX-3, front left
• ABS ring included with 44 teeth for proper speed signal operation
• New spindle nut included with M22 x 1.5 thread and 32mm hex head size
• Neoprene boot design uses added bellows where needed to reduce stress and ozone cracking
• Shafts are individually verified for straightness to help reduce vibration
• High-temperature grease is used for demanding torque and heat conditions
• Boot clamps are pneumatically crimped for a secure boot-to-housing seal
• Transmission seal diameter is precision-machined after heat treatment for correct surface finish

Product Details

Cardone 66-8084 is part of the CV Axle Assembly line, a product range focused on OE-style driveline replacement for front-wheel-drive vehicles. This assembly is engineered from Cardone’s CV axle testing and remanufacturing experience, with attention to the failure modes that commonly affect original axles, including boot cracking, grease loss, contamination, and vibration. For drivers servicing a Mazda Protege, Mazda MX-3, or Kia Sephia, this front left axle is built to restore smooth power transfer from the transaxle to the wheel hub.

This part cross-references Mazda F06925600 and Kia OK24A25600 for the same application.

What This Axle Helps Address

• Clicking or snapping noises during hard turns and acceleration
• Grease leakage around the axle boot or suspension area
• Front-end vibration caused by axle runout or shaft imbalance
• ABS warning light concerns related to the axle-mounted tone ring
• Grinding or binding from a worn outer or inner CV joint

Installation Notes and Tips

• Fits 1995-1998 Mazda Protege, front left; 1994-1997 Kia Sephia, front left; and 1992-1995 Mazda MX-3, front left.
• Do not let the CV axle hang unsupported during service, as this can damage the inner joint.
• Use a torque wrench on the spindle nut and tighten to the vehicle manufacturer’s specification.
• Do not reuse the old prevailing-torque axle nut; install the supplied new nut.
• Replace transaxle seals when servicing the axle to help prevent leaks.
• If the ABS light remains on after installation, inspect the sensor ring, sensor, and nearby wiring for damage.

Quality Assurance

Cardone verifies axle shafts for straightness and runout to help deliver vibration-free performance at speed. The brand’s CV axle engineering also focuses on boot durability, seal integrity, and consistent joint operation to support reliable OE-level replacement performance.