Cardone 66-8093 CV Axle Assembly - Front Left

Cardone CV Axle Assembly for Mazda Millenia

Restore smooth driveline operation with the Cardone CV Axle Assembly, part number 66-8093. This new front left axle is built for 1995-2000 Mazda Millenia applications and is engineered to address common CV joint and boot failure points with a focus on straightness, sealing, and vibration control.

Cardone’s CV axle line is developed from extensive testing and engineering experience, with design updates aimed at reducing repeat failures. For Mazda Millenia front left replacement needs, 66-8093 provides the correct splined connection, ABS ring provision, and a new spindle nut for a cleaner service job.

Key Features

• Fits 1996-2000 Mazda Millenia, front left
• Fits 1995 Mazda Millenia, front left, from chassis #138177
• Part number 66-8093
• ABS ring included with 44-tooth count
• New spindle nut included; M22 x 1.5 thread, 32mm hex
• Stake-style axle nut locking type
• Compressed length: 25.25 in.
• Input shaft: 30-spline, splined connection
• Output shaft: 28-spline, splined connection
• Neoprene boot design with added bellows where needed to reduce stress and cracking
• Individually verified shaft straightness for vibration-free operation
• High-temperature, high-torque grease for driveline durability

Detailed Description

The Cardone 66-8093 CV axle assembly is a direct replacement for the front left position on Mazda Millenia models listed above. It is built with a focus on the details that matter in CV driveline service: boot sealing, shaft runout control, and proper joint operation under load. Cardone also uses pneumatically crimped boot clamps and precision-machined seal surfaces to support long-term sealing performance.

This CV axle assembly is a practical choice when servicing a Mazda Millenia with clicking during turns, vibration on acceleration, grease leakage around the axle boot, or ABS-related concerns tied to the axle sensor ring. This part cross-references Mazda OE numbers GR052560XA and GR052560XE for the same application.

What It Helps Fix

• Clicking or snapping noises during hard turns
• Grease on the chassis or suspension from a ruptured CV boot
• Front-end vibration caused by axle runout or joint wear
• ABS warning light issues related to a damaged or incorrect sensor ring
• Thumping or shuddering during acceleration from worn CV joints

Installation Notes and Tips

• Fits 2000 Mazda Millenia, front left; 1996-1999 Mazda Millenia, front left; and 1995 Mazda Millenia, front left from chassis #138177.
• Do not let the axle hang unsupported during service, as this can damage the inner joint.
• Use a torque wrench on the spindle nut and tighten to the manufacturer specification; do not use an impact wrench for final installation.
• Replace the old prevailing-torque nut rather than reusing it.
• Inspect the hub, seals, and ABS sensor wiring before installation to avoid repeat faults.

Quality Assurance

Cardone builds this CV axle assembly using engineering methods developed to meet or exceed original equipment performance targets. Each shaft is checked for straightness to help reduce vibration, and the boot and seal design is intended to address common failure causes seen in CV axle service.