Cardone 66-8184 CV Axle Assembly - Front Left

Cardone CV Axle Assembly for Mazda 6

Restore smooth power transfer with this Cardone CV axle assembly, part number 66-8184, for select Mazda 6 front left applications. It is built for 2009-2013 Mazda 6 models and includes the details needed for a direct replacement on the driver-side front position.

Key Features

• Fits 2009-2013 Mazda 6, front left
• Cardone CV Axle Assembly, part number 66-8184
• ABS ring included for proper wheel speed signal setup
• New spindle nut included with a 32mm hex head and M22 x 1.5 thread
• Stake-style axle nut locking type
• 28-spline input shaft and 28-spline output shaft connection
• Compressed length: 26.87 in.
• Neoprene boot design with added bellows where needed to resist cracking and stress
• High-temperature, high-torque grease for consistent joint lubrication
• Boot clamps are pneumatically crimped for a secure seal
• Shafts are individually verified for straightness to reduce vibration

Product Details

Cardone engineers its CV drive axles using testing and remanufacturing methods focused on common failure points such as boot cracking, contamination, and vibration. The axle shaft is checked for runout and straightness, while the boot and grease package are selected to help maintain joint integrity under demanding driveline conditions. For Mazda 6 owners replacing a worn front axle, part number 66-8184 is a direct-fit solution for the front left side.

This part cross-references Mazda OE numbers GD812560XA and GP372560XA for the same application.

Common Problems This Part Can Address

• Clicking or snapping noises during turns
• Grease leakage around the axle boot
• Front-end vibration during acceleration
• Grinding noise from a worn CV joint
• ABS warning light concerns after axle replacement when the sensor ring is involved

Installation Notes

• Do not let the CV axle hang unsupported during service; support the shaft to avoid joint damage.
• Use a torque wrench on the retaining nut and tighten to the vehicle manufacturer’s specification.
• Do not reuse a prevailing-torque lock nut; install the supplied new spindle nut.
• Replace transaxle seals when servicing CV drive axle assemblies to help prevent leaks.
• Inspect the ABS sensor, wiring, and ring during installation to avoid signal issues.

Quality Assurance

Cardone’s CV axle engineering process is based on identifying why original axles fail and addressing those failure points in the replacement design. Each shaft is verified for straightness, and the boot, grease, and sealing details are selected to support reliable driveline performance on Mazda 6 front left applications.