Cardone 66-9015 CV Axle Assembly - Front Left

Cardone CV Axle Assembly for Mercedes-Benz ML

Cardone CV Axle Assembly 66-9015 is a new front left driveline replacement engineered for select Mercedes-Benz ML applications. It is built to address common CV axle failure points with a straightness-verified shaft, sealed boots, and precision-machined sealing surfaces for consistent operation.

Key Features

• Fits 2003-2005 Mercedes-Benz ML350, front left
• Fits 2002-2005 Mercedes-Benz ML500, front left
• Fits 1998-2003 Mercedes-Benz ML320, front left
• Fits 2000-2003 Mercedes-Benz ML55 AMG, front left
• Fits 1999-2001 Mercedes-Benz ML430, front left
• ABS ring included with 48 teeth for proper speed signal operation
• Self-lock spindle nut included with M24 x 1.5 thread and 36mm hex head size
• Splined input shaft with 37 splines and splined output shaft with 30 splines
• Compressed length: 24.75 in.
• Neoprene boots use added bellows where needed to resist stress and ozone cracking
• High-temperature, high-torque grease is used for durable joint lubrication
• Boot clamps are pneumatically crimped for a secure seal

Product Details

Cardone’s CV Axle Assembly line is engineered around the failure modes commonly seen in original CV axles, including boot cracking, grease loss, contamination, and vibration. Part number 66-9015 uses individually verified shaft straightness to help deliver smooth, vibration-free performance at speed. The transmission seal diameter is precision-machined after heat treatment to support proper sealing and long service life. This part cross-references Mercedes-Benz 1633300401 for the same application.

Common Problems This Part Can Address

• Clicking or snapping during hard turns and acceleration
• Grease on the chassis or suspension from a torn CV boot
• Front-end vibration caused by a bent or out-of-runout axle shaft
• ABS warning light issues related to a damaged sensor ring or axle-mounted sensor area
• Grinding or clunking from a worn outer CV joint

Installation Notes

• Fits 2003-2005 Mercedes-Benz ML350, front left; 2002-2005 Mercedes-Benz ML500, front left; 1998-2003 Mercedes-Benz ML320, front left; 2000-2003 Mercedes-Benz ML55 AMG, front left; and 1999-2001 Mercedes-Benz ML430, front left.
• Do not let the CV axle hang unsupported during service; this can damage the inner joint.
• Use a torque wrench for the spindle nut and tighten to the vehicle manufacturer’s specification.
• Replace the old prevailing-torque nut rather than reusing it.
• Install new transaxle seals when replacing CV drive axle assemblies to help prevent leaks.
• If the ABS light remains on after installation, inspect the sensor ring, sensor, and nearby wiring for damage.

Quality Assurance

Cardone designs and tests its CV drive axles to meet or exceed original equipment performance targets. Each shaft is checked for straightness, and the assembly uses materials and sealing details selected to reduce repeat failure in demanding driveline service.