Cardone 66-9229 CV Axle Assembly - Front Left

Cardone CV Axle Assembly for Volvo S40 and V40

Cardone 66-9229 is a new front left CV axle assembly for 2001-2004 Volvo S40 and 2001-2004 Volvo V40 applications. Built for OE-style driveline performance, it addresses common axle wear concerns with verified shaft straightness, durable boot construction, and a complete axle design for service replacement.

Key Features

• Fits 2001-2004 Volvo S40, front left
• Fits 2001-2004 Volvo V40, front left
• Cardone part number 66-9229
• ABS ring included with 43-tooth count
• Self-lock axle nut style with spindle nut included
• Compressed length: 23.25 in.
• 26-spline input and output shaft connection
• Neoprene boot design with added bellows where needed to reduce stress and cracking
• High-temperature, high-torque grease for driveline service
• Individually verified shaft straightness for reduced vibration

Product Details

Cardone’s CV Axle Assembly line is engineered around common failure points found in original CV axles. For Volvo S40 and Volvo V40 front left service, this assembly uses precision-machined sealing surfaces, pneumatically crimped boot clamps, and a boot design intended to resist ozone cracking and bellows stress. The axle shaft is checked for runout and straightness to help maintain smooth operation at speed. Part number 66-9229 is a direct replacement choice for drivers addressing worn joints, damaged boots, or ABS-related axle service on these Volvo platforms.

This part cross-references Volvo 8601984 and 8602741 for the same application.

Common Repair Reasons

• Clicking or snapping during turns from a worn outer CV joint
• Grease on the suspension or chassis from a ruptured boot
• Vibration or thumping during acceleration from axle runout or joint wear
• ABS warning light after axle replacement due to sensor ring or wiring damage
• Grinding or binding caused by internal CV joint damage

Installation Notes

• Do not let the axle hang unsupported during service; support the driveline to avoid inner joint damage.
• Use a torque wrench on the retaining nut and tighten to the vehicle manufacturer’s specification.
• Do not reuse a prevailing-torque lock nut; replace it with the supplied spindle nut.
• Install new transaxle seals when replacing CV axle assemblies to help prevent leaks.
• Inspect the ABS sensor ring, sensor, and wiring during installation to avoid an ABS fault.

Quality Assurance

Cardone engineers and tests CV drive axles to meet or exceed OE performance targets, with attention to boot durability, seal surface finish, and shaft straightness. The result is a replacement axle designed for consistent driveline operation in 2001-2004 Volvo S40 and 2001-2004 Volvo V40 front left applications.