Cardone 67-0014 Fuel Injection Throttle Body

Electronic Throttle Body for Nissan Applications

This remanufactured Cardone Fuel Injection Throttle Body is built for precise air control and OE-style fitment on select Nissan models. Part number 67-0014 is a direct replacement for vehicles that need a reliable electronic throttle body with integrated throttle position sensors.

Key Features

• Remanufactured electronic throttle body with electric actuation
• Integrated throttle position sensor included
• Round inlet and outlet design
• Aluminum housing with gray/unfinished finish
• Ultrasonic cleaning process helps preserve throttle bore shape for consistent airflow
• Each unit is disassembled, inspected, renewed or replaced as needed, and tested for response time and airflow
• OE-style fitment for a direct replacement on supported Nissan applications

Product Details

Cardone’s Fuel Injection Throttle Body line focuses on remanufactured OE replacement components for electronic throttle control systems. This part number 67-0014 is engineered for Nissan NV200, Sentra, Cube, and Versa applications where the throttle body regulates incoming air based on commands from the vehicle control module. The unit is tested across critical operating points, including sensor output, response time, and airflow, to help restore proper throttle operation.

This part cross-references Nissan 16119ET00A and 16119ET00B for the same application.

Common Issues This Part Can Address

• Throttle response problems caused by a worn electronic throttle body
• Check engine light related to throttle position sensor faults
• Idle instability from restricted or inconsistent airflow
• Limp mode or reduced engine speed after throttle control failure
• Driveability issues tied to throttle actuator or sensor wear

Installation Notes

• Perform a relearn calibration procedure after installation.
• Consult the vehicle service manual for the correct reset and adaptation steps.
• Do not bypass the coolant hoses unless the OE service information specifically calls for rerouting.
• Use the vehicle’s diagnostic procedure to confirm throttle body operation after installation.

Quality Assurance

Each Cardone remanufactured throttle body is disassembled, cleaned, inspected, and tested before release. Damaged or worn components such as sensors, gears, connectors, and seals are renewed or replaced based on engineering standards. The remanufacturing process also reduces raw material and energy use compared with producing a new part.

Compatible With 2007-2019 Nissan Sentra, 2009-2014 Nissan Cube, 2007-2012 Nissan Versa, and 2013-2021 Nissan NV200. Part number 67-0014 is a direct-fit replacement for these Nissan throttle body applications.