Cardone 67-0021 Fuel Injection Throttle Body

Remanufactured Electronic Throttle Body for Nissan Versa

Cardone 67-0021 is a remanufactured fuel injection throttle body built for precise air control and OE-style fitment. It is engineered for 2012-2019 Nissan Versa and 2014-2019 Nissan Versa Note applications, with the throttle position sensor included and electric actuation for modern drive-by-wire systems.

Key Features

• Remanufactured Original Equipment-style throttle body for direct replacement fit
• Electric throttle body actuation with round inlet and outlet shapes
• Integrated throttle position sensor included
• Aluminum housing with gray/unfinished finish
• Ultrasonic cleaning process helps preserve throttle bore geometry for consistent airflow
• Final testing covers response time and airflow at multiple points
• Remanufacturing reduces raw material and energy use versus producing a new part

Product Details

This Cardone Fuel Injection Throttle Body line focuses on restoring factory-style operation for electronic throttle systems. Each unit is disassembled, inspected, renewed, or replaced as needed, then tested to verify critical functions. The integrated high and low throttle position sensors are checked against OE characteristics across the operating range, helping maintain accurate throttle control in Nissan Versa and Nissan Versa Note models. Part number 67-0021 is a practical replacement when the original throttle body shows wear, sensor faults, or airflow irregularities.

This part cross-references Nissan 161193AN0A and 161193AN0C for the same application.

Common Issues This Part Can Address

• Check engine light related to throttle body or throttle position sensor faults
• Rough idle or unstable idle speed
• Delayed throttle response or reduced acceleration response
• Fail-safe mode operation after electronic throttle failure
• Airflow inconsistency caused by worn internal components or bore contamination

Installation Notes

• Fits 2012-2019 Nissan Versa, N/A
• Fits 2014-2019 Nissan Versa Note, N/A
• A relearn calibration procedure is required after installation
• Consult the vehicle service manual for the correct relearn and setup steps
• Do not bypass the coolant hoses unless the OE service information specifically calls for rerouting
• Throttle body spacers are not recommended for this application

Quality Assurance

Cardone remanufactures this throttle body through a controlled disassembly, inspection, cleaning, and renewal process. Each unit is tested for response time, airflow, and sensor performance to help ensure reliable operation before it leaves the remanufacturing process.