Cardone 72-1167 Engine Control Module

Engine Control Module for Toyota Van

Restore engine management performance with this remanufactured Cardone Engine Control Module, part number 72-1167. It is built for the 1987 Toyota Van and is pre-programmed at the factory for the listed application, making it a direct replacement for the original ECM.

Key Features

• Remanufactured original equipment-style ECM for a precise vehicle fit
• Fits 1987 Toyota Van, N/A
• Factory pre-programmed for the listed application
• Aluminum housing for durable module construction
• 3 rectangular connectors with blade-style male terminals
• Computer tested and on-car validated for durability and performance
• Remanufacturing process reduces raw material and energy use versus new-part production

Product Details

Cardone Engine Control Module 72-1167 is remanufactured to meet or exceed original equipment performance expectations. The module is rebuilt with critical components re-soldered or replaced at Cardone’s Philadelphia manufacturing plant, then tested to verify function before release. For Toyota Van owners, this ECM is a direct-fit replacement that supports proper engine control and drivability when the original unit has failed.

This part cross-references Toyota 8966128060 for the same application.

Common Problems This ECM Can Address

• No-start condition caused by a failed engine control module
• Intermittent stalling or rough running related to ECM failure
• Check engine light concerns tied to module malfunction
• Loss of fuel, ignition, or sensor control from a damaged control unit
• Driveability issues after confirming wiring, grounds, and related components are in good condition

Installation Notes and Tips

Before replacing the original ECM, verify the root cause of the failure. Common causes include poor grounds, power supply issues, damaged wiring harnesses, and shorted solenoids or relays. Confirm the Ford Engineering ID note does not apply here; for this Toyota Van application, match the original part number and connector layout before installation. Because this unit is pre-programmed at the factory, no flash programming is required.

For 1987 Toyota Van service, inspect connectors, terminals, and harness condition during installation to help prevent repeat failures. If the vehicle has additional electrical faults, correct those first so the replacement module is not exposed to the same problem.

Quality Assurance

Cardone remanufactured electronic and powertrain control modules are reverse-engineered to identify original design weaknesses and correct them during the rebuild process. Each unit is 100% computer tested, and on-car validation is used to confirm durability and performance for the listed application. Part number 72-1167 is a remanufactured ECM built for dependable replacement service in the Toyota Van.