Cardone 72-1195 Engine Control Module

Remanufactured ECM for Toyota Pickup

This Cardone Engine Control Module is a remanufactured replacement for select 1989-1990 Toyota Pickup applications with California Emission System calibration. Built as an OE-style electronic control module, it is designed to restore engine management performance with the correct fit, connector layout, and tested operation.

Key Features

• Fits 1989-1990 Toyota Pickup, N/A
• Cardone part number 72-1195 for direct replacement lookup
• Remanufactured aluminum housing for OE-style fitment
• 3 rectangular connectors with blade-style male terminals
• Critical components are re-soldered or replaced during remanufacturing
• 100% computer tested for electrical reliability
• No flash programming required and not flashable
• Earth-friendly remanufacturing process reduces raw material and energy use

Product Details

Cardone’s Engine Control Module line focuses on remanufactured electronic and powertrain control units that are returned to service after inspection, repair, and testing. For this application, the module is pre-programmed at the factory for vehicles with California Emission System requirements, making it a direct replacement option for the Toyota Pickup ECM platform. The aluminum case, connector configuration, and terminal layout are matched to the original design for proper installation and electrical connection. This part number 72-1195 is intended for 1989-1990 Toyota Pickup models listed in the fitment data.

This part cross-references Toyota 8966135160 for the same application.

What It Can Help Resolve

• Engine no-start caused by a failed control module
• Intermittent drivability issues tied to ECM internal faults
• Incorrect fuel or ignition control from a damaged module
• Check engine concerns related to control module failure
• Electrical problems traced to worn solder joints or failed internal components

Installation Notes

Before replacing the original ECM, verify the root cause of the failure. Common causes include poor grounds, power supply issues, damaged wiring harnesses, and shorted solenoids or relays. Confirm the original engineering number and connector configuration match this unit before installation. This application does not require flash programming, and the module is not flashable.

Quality Assurance

Each Cardone remanufactured control module is reverse engineered to identify original failure points, then repaired with re-soldered or replaced critical components and computer-tested for function. On-car validation is used on applicable units to confirm durability and performance. The remanufacturing process also reduces energy and raw material use compared with producing a new part.