/live/media/A1/A1_721211_Fro.jpg)
Cardone 72-1211 Engine Control Module
| Brand | Cardone 72-1211 |
|---|---|
| Connector Shape | Rectangle |
| E-Waste | Yes |
| Flash Programming Required | No |
| Flashable | No |
| Housing Material | Aluminum |
| Mounting Hardware Included | No |
| Product Condition | Remanufactured |
| Removable PROM | No |
| Terminal Type | Pin|Male; Blade|Male |
| Product line | Engine Control Module |
| Fits | Toyota · 2 vehicles |
OE direct replacement. Remanufactured to meet or exceed original equipment performance.
Computer tested. Each unit is verified for functionality and reliability before it ships.
Aluminum housing. Helps protect internal electronics while keeping the module lightweight.
Cross-references Toyota 1757002920 and Toyota 8966112491 for the same application. See all 2.
Cardone Remanufactured ECM for Toyota Corolla
Cardone 72-1211 is a remanufactured engine control module built for direct replacement in select Toyota Corolla applications. It is pre-programmed at the factory for the listed vehicles and uses a 2-connector layout with rectangular connectors for a proper OE-style match.
Key Features
- Remanufactured original equipment-style engine control module
- Fits 1991 Toyota Corolla with Federal Emission System, OE # 89661-12491
- Fits 1992 Toyota Corolla without California Emission System, OE # 89661-12491
- 2 connector design with rectangular connector shape
- Aluminum housing for OE-style fitment
- No flash programming required
- Factory pre-programmed for the listed applications
Product Details
Cardone’s Engine Control Module line focuses on remanufactured electronic and powertrain control units that are rebuilt to address common failure points found in the original design. For this application, critical components are re-soldered or replaced, then each unit is computer tested to verify operation before release. This Cardone 72-1211 ECM is a direct-fit replacement for Toyota Corolla models listed below and is intended for vehicles using the matching OE reference. This part cross-references Toyota OE numbers 1757002920 and 8966112491 for the same application.
What This ECM Can Help Resolve
- No-start or intermittent start conditions tied to a failed ECM
- Driveability problems caused by incorrect fuel or ignition control
- Check engine light concerns related to module failure
- Communication or powertrain control issues from an aging control unit
- Electrical faults caused by damaged internal module components
Installation Notes
Fits 1991 Toyota Corolla, N/A. Fits 1992 Toyota Corolla, N/A. Verify the OE number on the original module before ordering, and inspect grounds, power feeds, wiring harnesses, relays, and solenoids before replacing the ECM. Because this unit is pre-programmed at the factory and flash programming is not required, installation should focus on confirming the vehicle matches the listed emission and OE-number requirements.
Quality Assurance
Cardone remanufactures this ECM using a process that identifies original failure causes, corrects known weaknesses, and restores the unit with re-soldered or replaced critical components. Each module is computer tested, and on-car validation is used where applicable to confirm durability and performance. The remanufacturing process also reduces energy and raw material use compared with producing a new part.
| Year | Make | Model | Drive Type | Liters | Cylinders | Position | Notes |
|---|---|---|---|---|---|---|---|
| 1992 | Toyota | Corolla | FWD | 1.6L | L4 | N/A | without California Emission System; with OE # 89661-12491; This Unit is Pre-Programmed at the Factory; Engine Control Module |
| 1991 | Toyota | Corolla | — | — | — | N/A | with Federal Emission System; with OE # 89661-12491; This Unit is Pre-Programmed at the Factory; Engine Control Module |
| No rows match your filter. | |||||||