Cardone 72-1228 Engine Control Module

Engine Control Module for 1989 Toyota 4Runner

Restore engine management performance with this remanufactured Cardone Engine Control Module, part number 72-1228. It is built for the 1989 Toyota 4Runner with OE number 89661-35260 and is pre-programmed at the factory for the listed application.

Key Features

• Remanufactured original equipment-style ECM for a direct vehicle fit
• Fits 1989 Toyota 4Runner, engine control module application
• Three rectangular connectors with blade-style male terminals
• Aluminum housing for OE-style construction
• 100% computer tested for function and reliability
• Critical components are re-soldered or replaced during remanufacturing
• No flash programming required and not flashable
• Cross-reference: Toyota 8966135260

Product Details

Cardone’s Engine Control Module line focuses on remanufactured electronic and powertrain control units that are rebuilt to address common failure points found in the original design. For this 72-1228 ECM, Cardone uses reverse engineering to identify failure causes, then corrects weak points by re-soldering or replacing critical internal components at its Philadelphia manufacturing plant. The result is a remanufactured control module for the 1989 Toyota 4Runner that is validated through computer testing and on-car vehicle validation for durability and performance.

This part number 72-1228 is listed for the 1989 Toyota 4Runner with OE # 89661-35260. It is a direct-fit engine control module for buyers searching for a remanufactured Toyota 4Runner ECM, Toyota 4Runner ECU replacement, or 1989 Toyota 4Runner engine computer.

Common Problems This Part Can Address

• No-start or intermittent start condition caused by a failed ECM
• Driveability issues related to incorrect fuel or ignition control
• Check engine concerns tied to internal module failure
• Electrical faults caused by damaged solder joints or worn internal components
• Original module failure after poor power, ground, or wiring issues are corrected

Installation Notes

Before replacing the original ECM, verify the root cause of the failure. Common causes include poor grounds, poor power supply, damaged wiring harnesses, and shorted solenoids or relays. Confirm the OE number 89661-35260 and match the connector layout before installation. This unit is pre-programmed at the factory for the listed application, and no flash programming is required.

Quality Assurance

Cardone remanufactures this ECM to meet or exceed original equipment performance expectations. Each unit is computer tested, and the remanufacturing process is designed to reduce raw material and energy use compared with producing a new part.