Cardone 72-2001 Engine Control Module (ECM)

Remanufactured ECM for Honda Civic

This Cardone remanufactured engine control module is built for specific Honda Civic applications and is pre-programmed at the factory for the listed fitments. It is a direct replacement style ECM for vehicles that match the OE number and application details shown below.

Key Features

• Remanufactured Original Equipment-style engine control module
• Pre-programmed at the factory for listed applications
• Aluminum housing for the control module assembly
• Three connector interface with rectangular connector shape
• Cardone part number 72-2001

Detailed Description

Cardone 72-2001 is a remanufactured engine control module for select 1985-1987 Honda Civic applications, including listings with OE numbers 37820-PE7-682 and 37820-PE7-682RM. The module uses an aluminum housing and a three-connector layout with blade and pin male terminals. Cardone remanufactured electronic and powertrain control modules are engineered to address original design weaknesses, with critical components re-soldered or replaced and each unit computer tested for reliability. This part cross-references Honda 37820PE7681 and 37820PE7682 for the same application.

What It Is Used For

• Replacing a failed engine control module in a Honda Civic
• Restoring engine management and drivability after ECM failure
• Addressing intermittent electrical faults caused by internal module issues
• Correcting problems tied to damaged or weakened control module circuitry

Installation Notes and Tips

Verify the OE number on the original module before ordering, since fitment is tied to specific Honda Civic applications and emission configurations. The listed fitments are pre-programmed at the factory, and no flash programming is required. Before installation, inspect grounds, power feeds, wiring, and related solenoids or relays to confirm the original ECM is the source of the fault.

Quality Assurance

Cardone remanufactured control modules are computer tested, and the remanufacturing process includes re-soldering or replacement of critical components. The brand also validates durability and performance through on-car testing for applicable units.