Cardone 72-2722 Engine Control Module (ECM)

Cardone ECM for 2000 Honda Accord

Restore engine management performance with this remanufactured Cardone Engine Control Module, part number 72-2722. Built for the 2000 Honda Accord with OE number 37820-PAA-A01, this ECM is remanufactured to meet or exceed original equipment performance and is computer tested for reliability.

Key Features

• Remanufactured Original Equipment-style engine control module for a precise vehicle fit
• Fits 2000 Honda Accord, N/A, with OE # 37820-PAA-A01
• Three rectangular connectors with 32, 25, and 31 male pin terminals
• Aluminum housing for OE-style construction
• Critical components are re-soldered or replaced during remanufacturing
• 100% computer tested, with on-car validation used on applicable units
• No flash programming required and not flashable
• Earth-friendly remanufacturing process reduces raw material and energy use versus new part production

Product Details

Cardone’s Engine Control Module line focuses on remanufactured electronic and powertrain control units that are reverse engineered to identify common failure points and correct original design weaknesses. For this application, the Cardone 72-2722 ECM is built for the 2000 Honda Accord and cross-references Honda OE number 37820-PAA-A01. This part cross-references Honda 37820PAAA01 for the same application.

As a remanufactured ECM, this unit is intended to restore proper engine control functions, communication, and drivability when the original module has failed. The aluminum housing, connector layout, and terminal configuration are matched to the original design for direct replacement use on the listed vehicle.

Common Issues This ECM May Resolve

• No-start condition caused by a failed engine control module
• Intermittent stalling or rough running related to ECM failure
• Check engine light concerns tied to internal module faults
• Loss of engine management communication or control output
• Driveability problems traced to damaged internal solder joints or electronics

Installation Notes

Before replacing the original ECM, verify the root cause of the failure. Common causes include poor grounds and power supply issues, damaged wiring harnesses, and shorted solenoids or relays. Confirm the OE number on the original module matches the listed application before installation.

For 2000 Honda Accord ECM replacement, use the vehicle’s service information to inspect connectors, wiring, and related circuits before installing the replacement module. If the original unit was damaged by an external electrical fault, correct that issue first to help prevent repeat failure.

Quality Assurance

Cardone remanufactures this engine control module at its Philadelphia facility, where critical components are re-soldered or replaced and each unit is tested with computerized equipment to verify function. The remanufacturing process is designed to support OE-level performance while reducing material and energy use.