Cardone 72-3362 Engine Control Module

Remanufactured ECM for Nissan D21

This Cardone Engine Control Module is a remanufactured ECM built for direct replacement in select Nissan D21 applications. It is engineered to restore engine management performance with a unit that is computer tested and rebuilt with critical components re-soldered or replaced.

Compatible with 1992-1993 Nissan D21, N/A, this Cardone 72-3362 is a fitment-specific solution for pre-programmed applications without California Emission System requirements.

Key Features

• Remanufactured Original Equipment-style engine control module
• Fits 1992-1993 Nissan D21, N/A
• Aluminum housing with 64 blade-style male terminals
• 1 rectangular connector
• No flash programming required
• No removable PROM
• Computer tested for functionality and reliability
• Re-soldered or replaced critical components for improved electrical integrity

Product Details

Cardone’s Engine Control Module line focuses on restoring OE-level operation through remanufacturing rather than simple replacement. For this application, the module is rebuilt at Cardone’s Philadelphia manufacturing plant, where weak points from the original unit are identified and corrected. The result is a remanufactured ECM that supports proper fuel, ignition, and engine control operation in the Nissan D21 platform. Part number 72-3362 is also referenced for this application under Nissan 2371086G03 and MECMT112.

Common Problems This ECM Can Address

• No-start condition caused by a failed engine control module
• Intermittent stalling or rough running tied to ECM faults
• Check engine light concerns related to control module failure
• Driveability issues from damaged internal circuitry
• Electrical faults traced to poor solder joints or worn module components

Installation Notes

Before replacing the original ECM, verify the root cause of the failure. Common causes include poor grounds, power supply issues, damaged wiring harnesses, and shorted solenoids or relays. For Nissan D21 applications, confirm the original module identification and connector style before installation. This Cardone 72-3362 is a pre-programmed unit for the listed application and does not require flash programming.

Quality Assurance

Each unit is 100% computer tested, and Cardone uses reverse engineering to identify original design weaknesses and correct them during remanufacturing. The process also reduces raw material and energy use compared with producing a new part, supporting a more resource-efficient repair.