Cardone 73-80042 Transmission Control Module

Transmission Control Module for Honda Accord

Restore transmission electronics with this Cardone remanufactured transmission control module, part number 73-80042. It is built for quick installation, pre-programmed at the factory for the listed application, and engineered to meet or exceed OEM performance for a 1990 Honda Accord with Denshi Type and OE number 28100-PX4-922.

Key Features

• Remanufactured Cardone Transmission Control Module for electronic transmission management
• 100% computerized testing verifies function and electrical reliability
• Critical components are resoldered to improve connection quality and reduce intermittent faults
• Common wear components are fully replaced during remanufacturing
• Guaranteed fit and function for the listed Honda Accord application
• No flash programming required
• Connector/terminal configuration: Pin/Male; Pin/Male
• Terminal quantity: 26; 22

Product Details

Cardone’s Transmission Control Module line focuses on remanufactured electronic control units that are tested for form, fit, durability, and performance before release. This 73-80042 module is intended for direct replacement in the 1990 Honda Accord application listed below, with factory pre-programming already completed for the specified OE setup. The result is a service part built to restore transmission control behavior without requiring flash programming.

Fits 1990 Honda Accord, N/A, with Denshi Type; with OE # 28100-PX4-922; This Unit is Pre-Programmed at the Factory; Transmission Control Module.

This part cross-references Honda 28100PX4922 for the same application.

Common Problems This Part Can Address

• Transmission shifting concerns caused by a failing control module
• Intermittent electrical connection issues inside the module
• Faults related to worn internal solder joints or aged components
• Driveability problems tied to incorrect transmission control signals
• Replacement needs after diagnosis confirms module failure on a 1990 Honda Accord

Installation Notes

Verify the OE number, connector style, and transmission configuration before installation. This module uses Pin/Male connectors and does not require flash programming, but the vehicle should be checked for related wiring, grounds, and transmission faults before final installation. Confirm the application matches the 1990 Honda Accord with Denshi Type and OE 28100-PX4-922.

Quality Assurance

Each module is remanufactured, electronically tested, and validated to meet or exceed OEM performance targets. Cardone also performs on-car validation routines to confirm form, fit, durability, and performance requirements for the listed application.