Cardone 77-1598F Powertrain Control Module

Cardone PCM for Chevrolet Equinox and Malibu

Restore engine management performance with this Cardone remanufactured Powertrain Control Module, part number 77-1598F. Built for direct OE-style fitment, it is engineered for the 2005 Chevrolet Equinox and the 2004 Chevrolet Malibu with OE numbers 12581598 and 12591027.

Key Features

• Remanufactured Original Equipment-style PCM for precise vehicle fit
• Critical components are re-soldered or replaced at Cardone’s Philadelphia manufacturing plant
• 100% computer tested for electrical function and reliability
• On-car validation is used to check durability and performance
• Earth-conscious remanufacturing process reduces raw material and energy use versus new part production

Product Details

Cardone’s Powertrain Control Module line focuses on correcting common failure points found in original modules. Through reverse engineering, the unit is evaluated to identify design weaknesses that contributed to the original failure, then rebuilt with attention to electrical integrity and long-term operation. This approach supports dependable engine control on applications such as the Chevrolet Equinox and Chevrolet Malibu, where accurate PCM operation is critical for starting, drivability, and emissions-related functions. Part number 77-1598F is a remanufactured replacement for vehicles requiring OE-level module matching and programming.

This part cross-references Chevrolet OE numbers 12581598 and 12591027 for the same application.

What It Can Help Resolve

• No-start condition after PCM failure
• Intermittent drivability problems caused by internal module faults
• Check engine light concerns related to control module operation
• Communication or powertrain management issues tied to a failed PCM
• Vehicle performance problems after an original module has been diagnosed as faulty

Installation Notes and Tips

• Fits 2005 Chevrolet Equinox, N/A.
• Fits 2004 Chevrolet Malibu, N/A, with OE # 12581598 or 12591027.
• Vehicle-specific flash programming is required on or off the vehicle for the Malibu application.
• Accurate VIN and mileage information are required for programming.
• Vehicle-specific on-car programming must be performed after installation to avoid drivability and starting issues.
• Before replacing the original ECM/PCM, verify the root cause of failure, including grounds, power feeds, wiring harness condition, and shorted solenoids or relays.
• Chrysler PCM units with a V suffix require VIN programming; Ford PATS reset requirements vary by application; GM vehicles may require Passlock or Passkey VATS reset procedures depending on the system.

Quality Assurance

Cardone remanufactured electronic and powertrain control modules are built to meet or exceed OE performance expectations. Each unit is computer tested, and critical electrical connections are restored during remanufacturing to support consistent operation. The product line is backed by Cardone’s engineering process focused on identifying original failure points and correcting them during rebuild.