Cardone 77-1735F Powertrain Control Module

Remanufactured PCM for GM 3.1L/3.8L Applications

This Cardone Powertrain Control Module is a remanufactured engine control module built for specific 1999-2000 Buick, Chevrolet, Oldsmobile, and Pontiac applications. Part number 77-1735F is a direct-fit electronic control solution for vehicles that require vehicle-specific flash programming and accurate VIN and mileage data.

Key Features

• Cardone Powertrain Control Module, part number 77-1735F
• Remanufactured metal housing for OE-style module replacement
• Pin/male connector and terminal configuration
• Vehicle-specific flash programming required for installation
• Compatible with applications that use OE reference 9361735
• Fits 1999-2000 Buick LeSabre, N/A
• Fits 2000 Chevrolet Impala, N/A
• Fits 1999-2000 Chevrolet Monte Carlo, N/A
• Fits 1999-2000 Pontiac Bonneville, N/A
• Fits 2000 Pontiac Grand Prix, N/A

Detailed Description

Cardone’s Powertrain Control Module line focuses on remanufactured electronic control units for vehicle-specific engine management needs. This 77-1735F PCM is built with a metal housing and pin/male connectors, and it is listed for multiple GM passenger car applications including Buick LeSabre, Chevrolet Impala, Chevrolet Monte Carlo, Pontiac Bonneville, and Pontiac Grand Prix. The module cross-references OE number 9361735 for the same application family and is intended for vehicles that require precise programming to match the original calibration.

Because this PCM is application-specific, correct VIN and mileage information are required before and after installation. For 2000 Pontiac Grand Prix and 1999 Chevrolet Malibu applications, vehicle-specific flash programming is required on or off the vehicle, followed by on-car programming after installation to avoid drivability and starting concerns. This part number, 77-1735F, is also listed across additional 1999 Buick, Chevrolet, Oldsmobile, and Pontiac models within the same control module family.

What This PCM Helps Address

• Hard starting or no-start conditions related to a failed control module
• Drivability problems caused by corrupted or incorrect PCM calibration
• Check engine light concerns tied to module communication faults
• Loss of proper fuel, spark, or transmission control strategy
• Replacement needs after water intrusion, electrical damage, or internal module failure

Installation Notes and Tips

Verify the OE number, connector style, and vehicle application before ordering. This module requires vehicle-specific flash programming, and accurate VIN and mileage information must be supplied for proper setup. On-car programming after installation is essential on the listed applications to help prevent drivability and starting issues. Confirm that the replacement module matches the original connector/terminal configuration and that all related wiring and grounds are in good condition before programming.

Quality Assurance

This Cardone PCM is remanufactured and built with a metal housing for OE-style replacement use. It is an electronic control module and is marked as e-waste, so proper handling and disposal practices should be followed.