Cardone 77-3827F Powertrain Control Module

Remanufactured PCM for GM Applications

Cardone 77-3827F is a remanufactured Powertrain Control Module built for specific Buick, Chevrolet, Oldsmobile, and Pontiac applications from 2003-2005. This PCM uses a metal housing and pin/male connector terminals, and it requires vehicle-specific flash programming with accurate VIN and mileage information for proper operation.

Compatible With 2003-2005 Buick Century, LeSabre, Park Avenue, Rendezvous, and Regal; 2003-2005 Chevrolet Impala, Malibu, and Monte Carlo; 2003-2005 Pontiac Aztek, Bonneville, Grand Am, Montana, and Grand Prix; and 2003-2004 Oldsmobile Alero and Silhouette.

Key Features

• Remanufactured Powertrain Control Module for engine management and drivability control
• Metal housing for durable module construction
• Pin/male; pin/male connector/terminal configuration
• Vehicle-specific flash programming required for on-vehicle and off-vehicle installation
• Accurate VIN and mileage data required for programming
• Cross-references OE part number 12583827 for the same application

Product Details

Cardone Powertrain Control Module 77-3827F is a remanufactured PCM for GM vehicles that use OE part number 12583827. The Cardone Powertrain Control Module line focuses on replacement engine control electronics that must be programmed to the vehicle before use. For this application, post-installation on-car programming is essential to avoid drivability and starting concerns. This part is used across Buick Century, Chevrolet Impala, Pontiac Grand Am, and related GM platforms where precise calibration is required.

Common Issues This PCM May Address

• Engine no-start conditions related to a failed control module
• Drivability problems caused by corrupted or incorrect PCM calibration
• Communication faults tied to module failure
• Starting issues after PCM replacement without proper flash programming
• VIN or mileage mismatch concerns after module service

Installation Notes

• Vehicle-specific flash programming is required for both on-vehicle and off-vehicle installation.
• Provide accurate VIN and mileage information before programming.
• Post-installation on-car programming is essential for correct operation.
• Confirm connector style and application match before installation.
• Professional programming equipment and GM-specific service procedures are recommended.

Quality Assurance

This remanufactured Cardone PCM is built for OE-style replacement use and is supplied in a metal housing with the specified connector configuration. E-waste designation is marked as yes for this electronic control module.