Cardone 77-8051F Powertrain Control Module

Powertrain Control Module for GM V8 Applications

Cardone 77-8051F is a remanufactured powertrain control module built for specific 1994-1995 Buick, Cadillac, Chevrolet, and Pontiac applications. This PCM uses a metal housing and pin/male connector terminals, and it is supplied for vehicles that require vehicle-specific flash programming and VIN/mileage matching after installation.

Key Features

• Remanufactured powertrain control module for engine management and drivability control
• Metal housing for OE-style module construction
• Pin/male connector and terminal configuration: Pin/Male; Pin/Male; Pin/Male; Pin/Male
• Requires vehicle-specific flash programming on or off the vehicle
• Accurate VIN and mileage information required for programming
• Knock module must be transferred from the original PCM to the replacement unit
• Cardone 77-8051F cross-references Buick 16188051 and Cadillac 16188051 for the same application

Product Details

Cardone Powertrain Control Module 77-8051F is a remanufactured PCM for GM vehicles that rely on application-specific calibration. It is used in 1994-1995 Buick Roadmaster, Cadillac Commercial Chassis, Cadillac Fleetwood, Chevrolet Camaro, Chevrolet Caprice, and Pontiac Firebird models. Because this module must be flashed with the correct vehicle data, it is important to provide the exact VIN and mileage before or during programming to avoid starting or drivability concerns.

What This PCM Helps Address

• Engine control faults related to a failed original PCM
• Starting issues caused by an incorrect or unprogrammed control module
• Drivability problems tied to corrupted PCM calibration
• Communication or calibration mismatch after PCM replacement
• Check engine concerns linked to module-level control failures

Installation Notes and Tips

• Vehicle-specific flash programming is required on or off the vehicle.
• Provide accurate VIN and mileage for proper programming.
• Perform on-car programming after installation to help prevent drivability and starting issues.
• Transfer the knock module from the original PCM into the replacement PCM before final setup.
• Verify connector condition and terminal alignment before installation.

Quality Assurance

This Cardone powertrain control module is remanufactured and built for direct application-specific use in the listed GM vehicles. The metal housing and OE-style connector layout support proper module replacement when the original PCM has failed.