Cardone 78-2191F Engine Control Module

Engine Control Module for Ford Ranger and Mazda B2300

The Cardone 78-2191F remanufactured Engine Control Module (ECM) is built for direct replacement in select Ford Ranger and Mazda B2300 applications. It is remanufactured to meet or exceed original equipment performance, with critical components re-soldered or replaced and each unit computer tested for reliability.

Key Features

• Remanufactured Original Equipment-style ECM for a precise vehicle fit
• Fits 2007-2011 Ford Ranger and 2007-2009 Mazda B2300 applications listed below
• Vehicle-specific flash programming required on or off the vehicle
• Accurate VIN and mileage information required for proper setup
• PATS module programming required after ECM installation on Ford Ranger applications
• Critical electrical components are re-soldered or replaced during remanufacturing
• 100% computer tested for function and reliability
• Earth-conscious remanufacturing process reduces raw material and energy use versus new part production

Detailed Description

Cardone Engine Control Module part number 78-2191F is a remanufactured ECM for select Ford Ranger and Mazda B2300 models with module ID VK3-L5714 or 5806. This unit is engineered from the original design, with known failure points addressed during the remanufacturing process to help restore proper engine management, drivability, and starting performance. For Ford Ranger and Mazda B2300 vehicles in this application, correct VIN and OE number verification are important before ordering, and on-car programming must be completed after installation to avoid drivability or no-start concerns.

This part cross-references Ford OE numbers such as 7L5A12A650APA and Mazda OE numbers such as 1FCA18881 for the same application. The Cardone 78-2191F is a practical replacement choice when the original ECM has failed and the vehicle needs a programmed control module that matches the listed calibration and module ID requirements.

What It Helps Fix

• Engine no-start conditions related to ECM failure
• Drivability problems caused by incorrect or corrupted module programming
• Intermittent electrical faults from weakened solder joints or internal module damage
• Check engine concerns tied to control module malfunction
• Starting issues after ECM replacement when VIN, mileage, or PATS setup is incomplete

Installation Notes and Tips

• Verify the Ford Engineering ID or Mazda OE number before installation.
• Confirm the vehicle has module ID VK3-L5714 or 5806 as listed in the fitment data.
• Vehicle-specific flash programming is required on or off the vehicle.
• Perform on-car programming after installation to prevent starting and drivability issues.
• Ford Ranger applications require PATS programming after ECM installation.
• Check the original failure cause first; poor grounds, bad wiring, and shorted solenoids or relays can damage the replacement module.
• Chrysler PCM VIN-programming and GM anti-theft reset notes in the FAQ do not apply to this part number unless your vehicle platform requires them separately.

Quality Assurance

Cardone remanufactured electronic and powertrain control modules are tested with automated computer equipment or bench-tested, depending on application, and validated on vehicle for durability and performance. The remanufacturing process is performed at Cardone’s Philadelphia manufacturing plant, where critical components are restored to help deliver dependable operation.

• Fits 2007-2011 Ford Ranger, N/A
• Fits 2007-2009 Mazda B2300, N/A