Cardone 79-0111V Engine Control Module (ECM)

Remanufactured ECM for Dodge Ram 1500

The Cardone 79-0111V Engine Control Module is a remanufactured electronic control unit for specific 1999 Dodge Ram 1500 applications with Federal Emission System equipment. It is built to restore factory-style engine management performance with vehicle-specific flash programming required for proper operation.

Key Features

• Remanufactured Original Equipment-style engine control module for a precise vehicle fit
• Three rectangular connectors with 32-pin male terminals per connector bank
• Aluminum housing for OE-style packaging and durability
• Critical components are re-soldered or replaced during remanufacturing
• Computer tested to verify function before release
• Flash programming required for VIN and mileage-specific setup
• Earth-friendly remanufacturing process reduces raw material and energy use versus new part production

Product Details

Cardone Engine Control Module 79-0111V is remanufactured to meet or exceed original equipment performance expectations. The unit is reverse engineered to identify common failure points, then rebuilt at Cardone’s Philadelphia manufacturing plant with attention to electrical integrity and long-term reliability. This module is used on 1999 Dodge Ram 1500 trucks with Federal Emission System calibration requirements, and the correct VIN and mileage data are required during flash programming. This part cross-references Dodge 56040111AA and 5073425AA for the same application.

Common Issues This ECM May Address

• Engine no-start caused by a failed control module
• Intermittent drivability problems tied to internal ECM faults
• Communication or calibration issues after module replacement
• Electrical failures related to worn solder joints or damaged internal components
• Incorrect engine management behavior after original module failure

Installation Notes and Tips

• Fits 1999 Dodge Ram 1500, N/A, with Federal Emission System and OE number 56040111AA-AG.
• Fits 1999 Dodge Ram 1500, N/A, with Federal Emission System and OE number 5073 425AA.
• Vehicle-specific flash programming is required on or off the vehicle.
• Accurate VIN and mileage information are required for programming.
• Before replacing the original ECM/PCM, verify power, grounds, wiring harness condition, and related relays or solenoids.
• Confirm the Ford, GM, or Chrysler anti-theft and programming procedure only when servicing those platforms; this application is for Dodge Ram 1500.

Quality Assurance

Each Cardone remanufactured engine control module is computer tested or bench-tested, depending on application, and validated for durability and performance. The remanufacturing process includes re-soldering or replacement of critical components to improve electrical connection quality and reduce intermittent failures.