Cardone 79-0346V Engine Control Module

Remanufactured ECM for 2000 Dodge Ram 1500 Van

Cardone 79-0346V is a remanufactured engine control module for select 2000 Dodge Ram 1500 Van applications. It is built to restore factory-style engine management performance with OE fit and application-specific flash programming requirements.

Key Features

• Remanufactured Original Equipment-style engine control module
• Three rectangular connectors with 32-pin male terminals
• Aluminum housing for OE-style mounting and durability
• Critical components are re-soldered or replaced during remanufacturing
• 100% computer tested for functionality and reliability
• Vehicle validation testing is performed to confirm durability and performance
• Earth-friendly remanufacturing process reduces raw material and energy use versus new part production

Product Details

Cardone’s Engine Control Module line focuses on restoring electronic and powertrain control performance through reverse engineering and failure analysis. For the 2000 Dodge Ram 1500 Van, part number 79-0346V is a remanufactured ECM that addresses original design weaknesses by replacing or re-soldering critical internal components. This helps deliver stable electrical connections and consistent module operation after installation.

This part cross-references Dodge OE numbers 56040346AB and 56040346AC for the same application. It is also relevant for 2000 Dodge Ram 1500 Van owners searching for a remanufactured ECM, Dodge Ram 1500 Van engine control module, or flash-programmed replacement computer.

What It Helps Resolve

• Engine no-start or hard-start conditions related to module failure
• Driveability problems caused by incorrect fuel or ignition control
• Communication faults tied to a failed engine control module
• Intermittent electrical issues from weakened internal solder joints
• Check engine concerns traced to ECM malfunction

Installation Notes

Fits 2000 Dodge Ram 1500 Van, with Mexico Emissions, and 2000 Dodge Ram 1500 Van, Federal Emission System. Vehicle-specific flash programming is required on or off the vehicle, and accurate VIN and mileage information are required. Verify the original module part number and application before installation. Prior to replacement, inspect grounds, power feeds, wiring harness condition, and related solenoids or relays to confirm the original ECM is the source of the fault.

Chrysler PCM units identified with a “V” suffix require VIN programming. If the vehicle uses theft-deterrent or security relearn procedures, follow the OE service information for the correct reset process.

Quality Assurance

Cardone remanufactures this ECM at its Philadelphia facility using computer testing and application-specific validation. The process is designed to meet or exceed OE performance expectations while supporting reliable operation in the 2000 Dodge Ram 1500 Van platform.