Cardone 79-1636V Engine Control Module

Remanufactured ECM for Chrysler Sebring

Cardone 79-1636V is a remanufactured engine control module built for 1999 Chrysler Sebring applications with OE number 4671636AA-AH. This ECM is flash programming required and is supplied as a direct-fit electronic control replacement for the original module.

Key Features

• Remanufactured Original Equipment-style engine control module for precise fitment
• 2 rectangular connectors with 40-pin male terminals
• Aluminum housing with 3 mounting holes
• Critical components are re-soldered or replaced during remanufacturing
• 100% computer tested for function and reliability
• Vehicle validation testing is performed on-car for durability and performance
• Earth-friendly remanufacturing process reduces raw material and energy use versus new part production

Product Details

Cardone’s Engine Control Module line focuses on restoring factory-level electronic control performance through reverse engineering, component-level repair, and final testing. Part number 79-1636V is a remanufactured ECM for the 1999 Chrysler Sebring and is referenced to Chrysler OE numbers 4671636AA through 4671636AH. This module is built to meet the electrical and packaging requirements of the original unit, with flash programming required for proper vehicle operation.

This part cross-references Chrysler OE numbers such as 4671636AA and 4671636AH for the same application.

Common Problems This ECM Can Address

• Engine no-start caused by a failed control module
• Check engine light triggered by internal ECM faults
• Intermittent drivability issues related to module electronics
• Communication problems caused by damaged control circuitry
• Failure from heat-affected solder joints or worn internal components

Installation Notes and Tips

• Fits 1999 Chrysler Sebring, N/A.
• Vehicle-specific flash programming is required on or off the vehicle.
• Accurate VIN and mileage are required for programming.
• Before replacing the ECM, inspect grounds, power feeds, wiring harness condition, and related relays or solenoids.
• Verify the OE number on the original module matches the application before installation.

Quality Assurance

Each Cardone remanufactured ECM is computer tested after critical components are repaired or replaced. The remanufacturing process is performed at Cardone’s Philadelphia manufacturing plant and is focused on correcting common failure points found in original modules. Part number 79-1636V is built for 1999 Chrysler Sebring applications and is backed by Cardone’s remanufactured control module quality process.