Cardone 79-4514V Engine Control Module

Remanufactured ECM for Jeep Grand Cherokee

Cardone 79-4514V is a remanufactured engine control module built for precise OE-style fit and electronic performance. It is engineered for the 1998 Jeep Grand Cherokee with California Emission System requirements and vehicle-specific flash programming.

Key Features

• Remanufactured Original Equipment-style engine control module for direct fitment
• Fits 1998 Jeep Grand Cherokee, with California Emission System
• Flash programming required for vehicle-specific calibration
• Three rectangular connectors with 32-pin male terminals
• Aluminum housing for OE-style module construction
• Critical components are re-soldered or replaced during remanufacturing
• Computer tested for electrical function and reliability
• On-car validation is used to confirm durability and performance

Product Details

Cardone’s Engine Control Module line focuses on remanufactured electronic and powertrain control units that are rebuilt to address common failure points found in original modules. For this application, the 79-4514V is a remanufactured ECM for the 1998 Jeep Grand Cherokee, and it requires flash programming with accurate VIN and mileage data. The module uses three rectangular connectors, an aluminum housing, and pin-style male terminals to match the original vehicle configuration.

This part cross-references Jeep 56044514AA and 56044514AB for the same application.

Common Problems This ECM Can Address

• No-start or hard-start conditions caused by a failed engine control module
• Driveability issues related to corrupted or unstable ECM operation
• Communication faults tied to internal module failure
• Emission-system control problems on California Emission System vehicles
• Intermittent electrical faults caused by damaged internal solder joints

Installation Notes

Before replacing the original ECM, verify the root cause of the failure. Common causes include poor grounds, power supply issues, damaged wiring harnesses, and shorted solenoids or relays. This 1998 Jeep Grand Cherokee ECM requires flash programming, and accurate VIN and mileage information are required for setup. Confirm connector shape, terminal count, and application details before installation.

Quality Assurance

Cardone remanufactures this ECM by identifying original design weaknesses, reworking critical internal connections, and testing the unit with computerized equipment or bench procedures depending on the application. The remanufacturing process also reduces raw material and energy use compared with producing a new part.