Cardone 79-5550 Engine Control Module

Cardone Remanufactured ECM for Chrysler and Dodge

Cardone 79-5550 is a remanufactured engine control module built for direct replacement in select 1995 Chrysler Concorde and 1995 Dodge Intrepid applications. It is pre-programmed at the factory for the listed vehicles and uses a single rectangular connector with 60 male pin terminals for OE-style integration.

As part of the Cardone Engine Control Module line, this remanufactured ECM is engineered to restore factory-level electronic control after the original unit fails. The housing is plastic, flash programming is not required, and the unit is tested for function before release.

Key Features

• Remanufactured original equipment-style engine control module
• Fits 1995 Chrysler Concorde with OE number 4606550
• Fits 1995 Dodge Intrepid with federal emission system and OE number 4606550
• Factory pre-programmed for the listed application
• One rectangular connector with 60 pin male terminals
• Computer tested or bench-tested depending on application
• Critical components are re-soldered or replaced during remanufacturing
• No flash programming required

Detailed Description

Cardone 79-5550 is a remanufactured ECM designed to replace the original control module in 1995 Chrysler Concorde and 1995 Dodge Intrepid vehicles. Cardone uses reverse engineering to identify common failure points, then corrects those weaknesses during the remanufacturing process. The result is a direct-fit module that supports proper engine management and electronic communication in the vehicle.

This part cross-references Chrysler and Dodge OE number 4606550 for the same application. For fitment-based searches, this is a direct replacement ECM for 1995 Chrysler Concorde, N/A, and 1995 Dodge Intrepid, N/A.

What It Helps Address

• No-start or intermittent start conditions related to ECM failure
• Driveability problems caused by faulty engine control signals
• Communication issues from damaged internal module circuitry
• Electrical faults tied to worn solder joints or failed components
• Replacement needs after confirming the original ECM is the source of the issue

Installation Notes and Tips

• Verify the OE number on the original module before ordering.
• Inspect grounds, power feeds, wiring harnesses, relays, and solenoids before installation.
• Confirm the original failure was not caused by an external electrical problem.
• Use the vehicle’s OE service information for diagnosis and installation procedures.
• For Chrysler PCM applications with a V suffix, VIN programming may be required; confirm your exact module type before installation.

Quality Assurance

Cardone remanufactures this ECM at its Philadelphia facility, where critical components are re-soldered or replaced and each unit is computer tested for reliability. The remanufacturing process also reduces raw material and energy use compared with producing a new part.