Cardone 79-6102V Engine Control Module (ECM)

Remanufactured ECM for Chrysler and Dodge

The Cardone 79-6102V Engine Control Module is a remanufactured ECM built for specific 2004 Chrysler Sebring and Dodge Stratus applications. It is engineered to restore proper engine management with OE-style fitment, flash programming requirements, and validated electronic performance.

Key Features

• Remanufactured Original Equipment-style engine control module for precise vehicle fit
• 4 rectangular connectors with 38-pin male terminals
• Aluminum housing for OE-style mounting and durability
• Critical components are re-soldered or replaced during remanufacturing
• Computer tested and application-validated for reliability
• Flash programming required for vehicle-specific setup
• Fits 2004 Chrysler Sebring and 2004 Dodge Stratus applications

Product Details

Cardone Engine Control Module 79-6102V is part of the Cardone remanufactured electronic and powertrain control module line, which focuses on correcting common failure points found in original units. For this ECM, that means attention to solder joints, internal components, and electronic function before it leaves the manufacturing process. The result is a remanufactured control module intended for 2004 Chrysler Sebring and 2004 Dodge Stratus vehicles with the listed OE numbers and emission configurations.

This part cross-references Chrysler 04896102AA and Dodge 4896102AA for the same application. The 79-6102V part number is also important for VIN-based programming on Chrysler PCM applications with a V suffix, where accurate vehicle data is required during setup.

Common Problems This ECM Can Address

• Engine no-start caused by a failed control module
• Intermittent drivability issues tied to internal ECM faults
• Communication or powertrain control errors from damaged electronics
• Failure related to worn solder joints or internal component breakdown
• Replacement needs after diagnosing poor grounds, wiring faults, or shorted relays/solenoids

Installation Notes

Before replacing the original ECM, verify the root cause of the failure. Common causes include poor grounds, power supply issues, damaged wiring harnesses, and shorted solenoids or relays. This module requires flash programming, and Chrysler PCM units identified with a V suffix need VIN programming. For 2004 Dodge Stratus and Chrysler Sebring applications, confirm the OE number, emission system, VIN, and mileage before installation.

Some GM and Ford anti-theft systems may require additional reset procedures on other applications, but this part is listed for Chrysler and Dodge fitment only. Use an OE-approved service manual and follow the correct programming steps for the vehicle.

Quality Assurance

Cardone remanufactured control modules are reverse-engineered to identify original design weaknesses, then rebuilt with critical components re-soldered or replaced at the Philadelphia manufacturing plant. Each unit is computer tested to confirm electronic function and application reliability. The remanufacturing process also reduces raw material and energy use compared with producing a new part.