Cardone 79-6800V Engine Control Module (ECM)

Remanufactured ECM for Chrysler Sebring

Cardone 79-6800V is a remanufactured engine control module built for 2004 Chrysler Sebring applications with OE number 4896 810AA-AB. It is engineered to restore proper engine management, with flash programming required for vehicle-specific setup and accurate VIN and mileage input.

Key Features

• Remanufactured Original Equipment-style engine control module for a precise fit
• Two rectangular connectors with 40-pin male terminals
• Aluminum housing with three mounting holes
• Critical components are re-soldered or replaced during remanufacturing
• 100% computer tested for function and reliability
• On-car validation is used to verify durability and performance
• Earth-conscious remanufacturing process reduces raw material and energy use versus new part production

Product Details

The Cardone Engine Control Module line focuses on remanufactured electronic and powertrain control units that are returned to service after inspection, repair, and testing. For this application, the 79-6800V is a direct-fit ECM for the 2004 Chrysler Sebring and is built to meet OE performance expectations. This part cross-references Chrysler 04896810AB and 4896810AB for the same application.

Use Cardone 79-6800V when replacing a failed ECM on a 2004 Chrysler Sebring, especially when the original module has been affected by electrical faults, internal component failure, or programming-related issues. Accurate VIN and mileage data are required during flash programming.

Common Problems This ECM Can Address

• Engine no-start or intermittent start conditions tied to module failure
• Check engine light concerns caused by control module faults
• Driveability issues related to incorrect fuel, spark, or sensor control
• Communication problems between the ECM and vehicle systems
• Failure after poor grounds, wiring damage, or shorted relays/solenoids have been corrected

Installation Notes

Before replacing the original ECM, verify the root cause of the failure. Common causes include poor grounds and power supply issues, damaged wiring harnesses, and shorted solenoids or relays. For this 2004 Chrysler Sebring ECM, flash programming is required, and the vehicle-specific calibration must be completed with accurate VIN and mileage information.

Confirm connector style, terminal count, and OE number before installation. If the original unit was removed from a Chrysler PCM application with a V suffix, VIN programming is required.

Quality Assurance

Each Cardone remanufactured control module is tested with computer equipment or bench-tested, depending on application, and validated on vehicle for durability and performance. Re-soldering critical connections helps reduce intermittent electrical failures and supports long-term reliability.