Cardone 79-7362 Engine Control Module

Remanufactured ECM for 1993 Jeep Cherokee

This Cardone Engine Control Module is a remanufactured replacement for the 1993 Jeep Cherokee with California Emission System and without Police Package. It is built to restore factory-style engine management performance and is pre-programmed at the factory for the listed application.

• Remanufactured Original Equipment-style engine control module
• Fits 1993 Jeep Cherokee, N/A, with California Emission System; without Police Package
• Pre-programmed at the factory for the listed application
• 1 rectangle connector, 60 pin male terminals
• Plastic housing with 3 mounting holes
• No flash programming required and not flashable
• Reverse-engineered and corrected for known design weaknesses
• Critical components are re-soldered or replaced, then computer tested

Product Details

Cardone remanufactured electronic and powertrain control modules are engineered to meet or exceed original equipment performance. For this Cardone Engine Control Module, the remanufacturing process focuses on identifying failure points, repairing critical circuitry, and validating operation through computer testing. The result is a direct-fit ECM for the 1993 Jeep Cherokee application listed here, including OE reference 56027362 and Cardone part number 79-7362.

This part cross-references Jeep 56027362 for the same application.

Common Problems This ECM Can Address

• No-start or intermittent start conditions tied to ECM failure
• Rough running, stalling, or unstable idle caused by control module faults
• Check engine light concerns related to engine management electronics
• Driveability issues traced to damaged internal circuitry or solder joints
• Replacement needs after diagnosing poor grounds, wiring faults, or failed relays/solenoids

Installation Notes

Before replacing the original ECM, verify the root cause of the failure. Common causes include poor grounds and power supply issues, damaged wiring harnesses, and shorted solenoids or relays. Confirm the OE number on the original module matches the listed application before installation. This unit is pre-programmed at the factory for the specified 1993 Jeep Cherokee configuration and does not require flash programming.

Quality Assurance

Cardone remanufactured control modules are tested with automated computer equipment or bench-tested, depending on application, and validated on-vehicle for durability and performance. The remanufacturing process also reduces energy and raw material use compared with producing a new part, supporting a more resource-efficient repair path.