Cardone 79-7363V Engine Control Module

Remanufactured ECM for 1998 Dodge Durango

The Cardone 79-7363V Engine Control Module is a remanufactured ECM built for 1998 Dodge Durango applications with California Emission System requirements. It is engineered to restore proper engine management, with flash programming required for vehicle-specific calibration and VIN/mileage data on the listed applications.

Cardone’s Engine Control Module line focuses on remanufactured OE-style control units that are computer tested and rebuilt with attention to known failure points. For 1998 Dodge Durango owners, this part number 79-7363V is a direct-fit electronic control solution for the listed OE references.

Key Features

• Remanufactured Original Equipment-style ECM for precise vehicle fit
• Designed for 1998 Dodge Durango models with California Emission System
• Flash programming required for application-specific setup
• Aluminum housing with 3 rectangular connectors
• 32-pin male terminal design across three connectors
• Critical components are re-soldered or replaced during remanufacturing
• Computer tested for functionality and reliability
• On-car validation used to confirm durability and performance

Product Details

The Cardone Engine Control Module product line is built around remanufactured electronic and powertrain control modules that address common failure points found in original units. For this application, the 79-7363V ECM is intended for 1998 Dodge Durango vehicles listed with OE references 56040610AA and 56046363AA through 56046363AK. This part cross-references Dodge OE numbers 56040610AA and 56046363AA for the same application.

Because this ECM requires flash programming, the installer must verify the correct VIN and mileage information before installation. The module is not flashable and does not use a removable PROM. It is built with an aluminum housing and three rectangular connectors for the specified vehicle configuration.

Common Problems This ECM Can Address

• Engine no-start caused by a failed control module
• Driveability issues related to incorrect fuel or ignition control
• Check engine light concerns tied to ECM internal faults
• Intermittent stalling or poor running from module failure
• Communication or calibration problems after ECM replacement

Installation Notes

• Verify the OE engineering number and match it to Cardone 79-7363V before installation.
• Confirm the vehicle is a 1998 Dodge Durango with California Emission System and the listed OE reference.
• Flash programming is required; accurate VIN and mileage are needed for setup.
• Inspect grounds, power feeds, wiring harness condition, and related relays or solenoids before replacing the ECM.
• Follow an OE-approved service procedure for programming and final verification.

Quality Assurance

Cardone remanufactures this Engine Control Module by identifying original design weaknesses, then re-soldering or replacing critical components at its Philadelphia manufacturing plant. Each unit is computer tested, and on-car validation is used to confirm durability and performance before release.