Cardone 79-7400V Engine Control Module (ECM)

Remanufactured ECM for Chrysler and Dodge

Cardone 79-7400V is a remanufactured engine control module built for specific 2001 Chrysler Town & Country and 2001 Dodge Grand Caravan applications. It is engineered to restore proper engine management with OE-style fitment, flash programming requirements, and validated electronic performance.

Key Features

• Remanufactured Original Equipment-style engine control module for precise vehicle fit
• Two rectangular connectors with 40-pin male terminals
• Aluminum housing with three mounting holes
• Critical components are re-soldered or replaced during remanufacturing
• 100% computer tested for functionality and reliability
• Flash programming required for vehicle-specific calibration
• Earth-friendly remanufacturing process reduces raw material and energy use versus new part production

Product Details

The Cardone Engine Control Module line focuses on remanufactured electronic and powertrain control units that are returned to service after inspection, repair, and testing. For this application, the 79-7400V is built to match the original module layout and electrical interface used in Chrysler Town & Country and Dodge Grand Caravan models. Cardone’s remanufacturing process includes reverse engineering to identify common failure points, then correcting those weaknesses during rebuild. This part cross-references Chrysler OE numbers such as 04727403AA and 5127670AA for the same application.

Fits 2001 Chrysler Town & Country, N/A. Fits 2001 Dodge Grand Caravan, N/A. The 2001 Chrysler Town & Country application requires vehicle-specific flash programming on or off the vehicle, with accurate VIN and mileage information. The 2001 Dodge Grand Caravan application is listed without California Emission System and also requires vehicle-specific flash programming.

Common Issues This ECM May Resolve

• Engine no-start caused by a failed control module
• Intermittent drivability problems related to internal ECM faults
• Communication or calibration issues after module failure
• Check engine concerns traced to the original engine control module
• Vehicle performance problems caused by damaged electronic circuitry

Installation Notes and Tips

• Verify the original module part number and engineering ID before ordering.
• Confirm the failure source first; poor grounds, power supply issues, wiring damage, and shorted relays or solenoids can damage the replacement module.
• Flash programming is required for this part number, and Chrysler V-suffix PCM applications need VIN programming.
• Use an OE-approved service manual for programming and relearn procedures.
• Check vehicle security system requirements before installation, including Chrysler, Ford, or GM anti-theft reset procedures where applicable.

Quality Assurance

Each Cardone remanufactured ECM is computer tested to verify operation before release. The rebuild process includes re-soldering or replacing critical components to improve electrical integrity and reduce intermittent failures. Cardone also validates durability and performance through on-car testing on applicable units.