Cardone 79-7435 Engine Control Module

Engine Control Module for Chrysler and Dodge

The Cardone 79-7435 remanufactured Engine Control Module is built for direct replacement in select 1993 Chrysler Concorde and 1993 Dodge Intrepid applications. It is pre-programmed at the factory for the listed fitments and is remanufactured to restore proper engine management performance.

Key Features

• Remanufactured original equipment-style ECM for a precise vehicle fit
• Pre-programmed at the factory for the listed applications
• 60-pin male terminal design with 1 rectangular connector
• Plastic housing with 3 mounting holes
• 100% computer tested for function and reliability
• Critical components are re-soldered or replaced during remanufacturing
• Earth-friendly remanufacturing process reduces raw material and energy use versus new part production

Detailed Description

Cardone Engine Control Module 79-7435 is a remanufactured ECM for vehicles using OE part number 4605435. It is engineered to meet or exceed original equipment performance and is validated through automated testing and on-car vehicle validation where applicable. This module is a direct-fit electronic control solution for 1993 Chrysler Concorde and 1993 Dodge Intrepid, including the California emission application listed for the Intrepid.

This part cross-references Chrysler 4605435 for the same application. The Cardone engine control module line focuses on restoring factory-style electronic control by correcting common failure points found in the original unit.

What It Helps Resolve

• No-start or hard-start conditions caused by a failed ECM
• Driveability problems related to incorrect fuel or ignition control
• Check engine concerns tied to module malfunction
• Intermittent stalling or rough running from internal control faults
• Issues caused by damaged solder joints or worn electronic components

Installation Notes and Tips

Before replacing the original ECM, verify the root cause of the failure. Common causes include poor grounds, power supply issues, wiring harness damage, and shorted solenoids or relays. Confirm the OE number on the original module matches the listed application before installation. This unit does not require flash programming and does not use a removable PROM.

Fits 1993 Chrysler Concorde, N/A. Fits 1993 Dodge Intrepid, N/A, with California Emission System.

Quality Assurance

Each Cardone remanufactured control module is tested with computer equipment or bench-tested, depending on application, to verify operation before release. The remanufacturing process includes re-soldering or replacement of critical components to improve electrical integrity and long-term reliability.