Cardone 79-7522 Engine Control Module

Remanufactured ECM for Chrysler and Dodge

Cardone 79-7522 is a remanufactured engine control module built for specific 1986 Chrysler, Dodge, and Plymouth applications. It is pre-programmed at the factory for the listed vehicles and uses a two-connector, 25-pin-per-side design with an aluminum housing for direct replacement service.

Compatible with 1986 Chrysler Laser, LeBaron, New Yorker, and Town & Country; 1986 Dodge 600, Aries, Daytona, and Lancer; and 1986 Plymouth Reliant. This part number, 79-7522, is a direct-fit ECM for vehicles using OE references such as Chrysler 5227318 and related numbers.

Key Features

• Remanufactured original equipment-style engine control module
• Factory pre-programmed for the listed 1986 applications
• Two rectangular connectors for OE-style electrical connection
• Aluminum housing for durable module construction
• Critical components are re-soldered or replaced during remanufacturing
• 100% computer tested for function and reliability
• On-car validation is used to confirm durability and performance
• Earth-friendly remanufacturing process reduces raw material and energy use versus new part production

Product Details

Cardone’s Engine Control Module line focuses on remanufactured electronic and powertrain control units that are returned to service after inspection, repair, and testing. For this application, the module is rebuilt to address common failure points found in original units, with attention to solder joints and other critical electrical components. The result is a replacement ECM for Chrysler, Dodge, and Plymouth vehicles that matches the original fit and electrical layout for the listed 1986 models.

This part cross-references Chrysler OE numbers 5227318 and 5227522 for the same application.

What This ECM Helps Address

• No-start or hard-start conditions caused by a failed engine control module
• Driveability problems tied to incorrect fuel or ignition control
• Intermittent electrical faults from weakened internal solder connections
• Check engine concerns related to module failure
• Replacement needs after diagnosing power, ground, wiring, or relay issues

Installation Notes

• Verify the original failure before replacing the ECM; check grounds, power feeds, wiring harness condition, and related solenoids or relays.
• Confirm the OE engineering or module number matches the Cardone reference before installation.
• This unit is pre-programmed at the factory and does not require flash programming.
• Use the vehicle’s service information for proper diagnostic and installation procedures.
• For Chrysler PCM applications with a “V” suffix, VIN programming is required; review the vehicle-specific service data before ordering.

Quality Assurance

Each Cardone remanufactured control module is computer tested, and application-specific units may also be bench-tested or validated on the vehicle. The remanufacturing process is designed to correct known design weaknesses found in original modules while restoring reliable operation for the listed Chrysler, Dodge, and Plymouth applications.